Table of Contents
What size wrench Do I need to remove the oil drain plug?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.
What size is the oil plug on a 2006 Pontiac Grand Prix?
All plugs have 14mm hex – just one wrench works for all.
What size bolt is a oil drain plug?
Oil Drain Plug Standard M14-1.50, Head Size 17mm.
What size is oil filter nut?
Oil filter sockets have a larger socket head size than many other sockets, often between 30mm – 80mm (1¼” – 3⅛”).
What size is the oil plug on a 2008 Pontiac Grand Prix?
15mm
Dorman – Autograde – Oil Drain Plug Pilot Point M12-1.75, Head Size 15mm (Part No. 090-175.1)
What wrench do I need to change my oil?
Wrench. The most common tool used when changing motor oil is the combination wrench. This kind of wrench has both an open side and a closed side. The open end can be used to remove the wrench and position it on the nut.
Do you need a socket wrench to change oil?
A socket wrench is a tool used to grip the head of a fastener such as a nut or bolt to tighten or loosen it. You need a socket wrench to open the oil drain plug so the used oil can drain from the engine. First, turn on the car to warm up the engine. This thins the oil, allowing it to drain smoothly.
How do I size an oil filter wrench?
Count the number of flutes on the cap of your oil filter. Measure your oil filter from one edge to the other edge. Get the oil filter cap wrench that has the same number of flutes but let the inner diameter of the cap be bigger than the oil filter cap.
What wrench is used to remove an oil filter?
You can use a spider wrench with a 3/8-inch ratchet driver to remove the oil filter. There are two types of spider wrenches, claw, and jaw, and they grab the filter slightly differently. Spider wrenches are useful for filters tucked away in confined areas.
How much oil does a 3800 2 take?
Just put in 4 quarts of oil to start, then warm up the engine and check the level on the dipstick. Slowly add the last .