Table of Contents
How much oil does a 318 take?
The owners manual says 6 quarts with a filter change.
What’s the difference between 5W30 and 10W30 oil?
10w30 is thicker than 5w30 because it has a higher viscosity in low temperatures. The engine oil will flow slower than 5w30 during the cold season. Thicker or higher viscosity metal oil has a better seal compared to low viscosity oil. Thicker oil offers better lubrication of motor and engine parts.
Are 318 good engines?
The Good And The BadIn terms of durability, the Mopar 318 is robust. The bottom end of most 318 engines used a cast-iron crankshaft, and though these are not as desirable as a forged crank, the cast-iron piece has proven to be very reliable.
How much oil does a Mopar 360 take?
a 360 should hold 5 usa qts with filter change….
What type of oil does a 1999 Dodge Dakota use?
Engine Oil
| Viscosity: | 10W-30 (Above -18) SAE 10W-30 is preferred. 5W-30 (Below 0) |
|---|---|
| Capacity: | 4 quarts. (with filter)After refill check oil level. |
| Torque: | 25 ft/lbs (Oil Drain Plug) |
Is the 5.2 Magnum Fuel Injected?
INTAKE SYSTEM All Magnum engines are fuel injected. There are eight injectors — one per cylinder. They should be cleaned but can be re-used. The intake manifold is made of aluminum and can be used as is.
What is the oil capacity of a BMW 318?
BMW 318 engine oil capacity Engine Capacity/Filter capacity litres (liters) Oil Change Intervals 318i (1987 – 1991) M40 4 / 0.25 l 318i cat (1988 – 1991) M40 4 / 0.25 l 318is (1989 – 1991) M42 4.5 / 0.25 l
What kind of engine does a Chrysler 318 Magnum have?
The Chrysler 318 Magnum features a cast-iron block and two cast-iron heads with a single camshaft (OHV) and two valves per cylinder (16 valves in total). The Chrysler 3.9L Magnum engine is equipped with a multi-point fuel injection system and a mechanically timed electrical ignition system with an ignition coil and mechanical distributor.
How big is the intake valve on a Chrysler 318 Magnum?
The intake valve diameter is 48.665 mm (1.916 in), the duration is 250° the exhaust valve diameter is 41.250 mm (1.624 in), the duration is 264°. The Chrysler 318 Magnum engine is equipped with hydraulic valve tappets. ATTENTION!
How big is the crankshaft on a Chrysler 318?
The crankshaft main journal diameter is 63.5 mm (2.5 in) and the crankpin diameter is 53.0 mm (2.08 in). After securing bearing cap bolts, make sure crankshaft turns smoothly by hand. The cylinder heads are made of cats-iron. The engine has a single camshaft over-head valves. The camshaft is driven by a single timing chain.