Table of Contents
How do you remove an airbag control module?
Steps to remove airbag control module
- First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor.
- Disconnect the positive battery cable and wait 3 min.
- You are now safe to unplug the airbag control module harness wiring plugs.
What happens if you unplug airbag module?
What happens if you unplug airbag module? Disconnecting the airbag unit from the harness without unplugging the battery may trigger the airbags to deploy or may cause damage to the computer system. After disconnecting the positive battery cable, you should wait three minutes before removing the computer module.
Can you swap airbag module?
If there is an airbag deployment, it will need to be replaced with a new or used airbag. Airbags are not repaired and not repacked. The airbag control module however can be reset to clear crash history and then can be used again instead of purchasing a new airbag control module.
How long does it take to change a airbag module?
The repair work is expected to take about 2 hours to complete, depending on dealer schedules. While repair times can vary from 1 to 2 hours, wait times might be longer depending on dealer schedules.
Can you drive car with airbag module removed?
While a vehicle can still run without an airbag module, it is strongly recommended that drivers do not operate the vehicle without it being installed—unless an emergency situation arises and there is no other option. Without airbags deploying, a driver and any passengers can face severe injury or even death.
What does an airbag module do?
Thus, during a collision, the impact data is stored in the air bag module. You will know when this occurs because your airbag light will turn on until the airbag module is replaced or repaired. Safety Restore uses a OEM factory installed program to erase the crash data for airbag module reset.
Do you have to reprogram an airbag module?
After a vehicle has been in an accident, the airbag control module needs to be reset in order to be used again. Once repaired, it will not need to be coded to your vehicle VIN, since it is original and came out of your vehicle.
Do you have to replace airbag module after deployment?
It is imperative you have a mechanic replace the airbags in your vehicle after they deploy and before you drive the car again. Replacing an airbag requires special skills. The technician must remove the entire airbag module and replace it with a new one.