What transmission does my 1988 Ford Bronco have?
Ford Ranger and Bronco models were equipped with either C3 or A4LD transmissions and F-series trucks were issued C6, E4OD or AOD automatic transmissions.
Can you get the Bronco with a manual transmission?
Yes, even though it is currently only offered on 4-cylinder cars without the off-road-focused Sasquatch Package, The Drive reports that around 15 percent of all first-year Bronco buyers are opting for the manual transmission.
Which Bronco trim has manual transmission?
Ford has announced that the Sasquatch package, the best available trim on the Bronco two-door and four-door, will be available with the Bronco’s 7-speed manual transmission.
What model Bronco comes with manual transmission?
Citing feedback from reservation holders, Ford confirmed it has decided to offer the Bronco’s seven-speed manual transmission with the Sasquatch gear on both the SUV’s two- and four-door body styles.
What kind of transmission does a Ford Bronco have?
Ford Ranger and Bronco models were equipped with either C3 or A4LD transmissions and F-series trucks were issued C6, E4OD or AOD automatic transmissions. Count the number of bolts on the bottom pan on the transmission.
Can you swap a Bronco 302 for a 351W?
It is possible to swap in a 351W with many of the same components as the 302, but tight clearances make this much more difficult. The original Bronco II and Ranger transmissions are too weak to withstand V8 power and must be swapped for a heavier duty transmission.
How long does it take to swap a Chevy Bronco?
A quick guide to getting more power. A basic 302/5.0 or 351W swap should take 50-70 hours if using the components listed below. Before starting a conversion, we recommend that you check local and state vehicle regulations to ensure the modifications are legal.
Do you need a C4 bellhousing for a Bronco II?
You need to lengthen the rear driveshaft and the front shaft needs to be shorter. You can avoid shortening the front one by using a front driveshaft from an 1984-1985 Bronco II or Ranger, which is already 4.5″ shorter. To use a C4, you’ll need a C5 bellhousing.