Table of Contents
- 1 Do Bosch washing machines have transit bolts?
- 2 What happens if you don’t remove shipping bolts from washing machine?
- 3 How do I stabilize my Bosch washing machine?
- 4 How do I stabilize my washing machine drum?
- 5 Can I move my washing machine without the transit bolts?
- 6 How do I stop my Bosch washing machine from shaking?
Do Bosch washing machines have transit bolts?
All new washing machines are fitted with a transit bolts to protect the machine against damage in transit. Transit locks and bolts must be removed before you use your appliance.
What happens if you don’t remove shipping bolts from washing machine?
Failure to remove the shipping bolts and retainers before use may cause severe vibration and noise, which can lead to permanent damage to the washer. The second possible cause of excessive vibration is a shipping block that might be caught under the washer.
Why do washing machines have transit bolts?
A transit bolt, also called a washer shipping bolt, is installed through the back a washing machine to keep the tub from moving around during shipping.
What causes a washing machine to wobble?
Your washing machine needs to stand level and balanced on its feet to function properly. An unbalanced appliance will vibrate and shake during operation. Your washing machine might vibrate or shake during operation if the load inside the drum is unevenly distributed.
How do I stabilize my Bosch washing machine?
To level your appliance:
- Place a spirit level on the appliance.
- Turn the feet on the appliance until the spirit level is aligned.
- Secure the feet with the lock nuts by following the instructions in the installation guide.
- If the appliance is standing on a base, secure the feet with the clip holders.
How do I stabilize my washing machine drum?
Tilt your top-loading washing machine over at an angle to allow any standing water to flow out of the drainage opening. Place a towel over your water supply hose ending and hold it in place with a rubber band. Lay the covered end of the hose inside the washing machine drum.
Are washing machine shipping bolts universal?
Longer bolts belong in the bottom two openings on the panel. Some washers utilize bolts that are uniform in size. These are universal bolts, meaning they will fit in any of the four openings. Use a socket and wrench to tighten your shipping bolts, ensuring they will not be jostled loose during transport.
Do all new washing machines have transit bolts?
Normally when you get your new washing machine there will be two (rare), three or four transit bolts fitted through the rear panel of the washing machine that fix to the outer tank of the washing machine. These bolts must be removed before the washing machine is used.
Can I move my washing machine without the transit bolts?
Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.
How do I stop my Bosch washing machine from shaking?
To remove these loud noises, check the feet to ensure that the washing machine is evenly balanced and resting on a flat surface. Also check that the washing machine is parallel to the ground by using a spirit level. If it is not level, adjust the feet accordingly and tighten them in place.
How do I stop my violently washing machine from shaking?
Washing machines are not supposed to violently vibrate around….6 Tips to Stop Washing Machine Vibration
- Check that your loads are balanced.
- Check the the floor and machine are level.
- Ensure You Have a Sturdy Floor.
- Check Your Stacking Kit.
- Purchase Washing Machine Vibration Pads.
- Call in Some Reinforcement.