Menu Close

Does a Jeep Grand Cherokee have shocks or struts?

Does a Jeep Grand Cherokee have shocks or struts?

Since there are four generations of the Grand Cherokee, older models use shocks and modern ones are fitted with struts.

Is it easy to replace front shocks?

If you need to replace your car’s shock absorbers but don’t want to pay an expensive mechanic’s fee, you can do so on your own with a little effort. Shocks are essential to a car’s performance, giving it a smooth and even ride.

How much does it cost to replace shocks on a Jeep Grand Cherokee?

Jeep Grand Cherokee Suspension Shock or Strut Replacement Cost Estimate. Labor costs are estimated between $62 and $78 while parts are priced between $467 and $472. This range is based on the number and age of Jeep Grand Cherokee’s on the road.

Can you change shocks without a lift?

To replace rear shocks you do not need to jack up the car.

How do you change the shocks on a Jeep Cherokee XJ?

Open the hood and locate the top shock bolt. Remove the nut on the bolt….Slide the new shocks in place and reinstall the bottom bolts, upper rubber grommets, washers, and bolts.

  1. Figure 2. Remove the lower shock bolts.
  2. Figure 3. Remove the upper shock bolts.
  3. Figure 4. Install the new shocks.

How do I know if my shocks or struts are bad?

The Warning Signs Of Worn Shocks And Struts

  1. Instability at highway speeds.
  2. Vehicle “tips” to one side in turns.
  3. The front end dives more than expected during hard braking.
  4. Rear-end squat during acceleration.
  5. Tires bouncing excessively.
  6. Unusual tire wear.
  7. Leaking fluid on the exterior of shocks or struts.

How often should I replace my front shocks on my Jeep Cherokee?

The front shocks on a Jeep Cherokee take on a lot of responsibility in the front suspension. While the coil springs share the load of the engine, you can optimize the performance of your ride by replacing the front shocks every 30,000 miles or so.

Where are the shocks on a Jeep Grand Cherokee?

Open the hood and locate the upper shock bolts inside the engine compartment. These are on each side of the engine on the fender wells. Remove the nut with a 14 mm socket and a ratchet. Remove the nut from the bolt that secures the shock to the mounting bracket on the axle with a ratchet and socket. Pull the bolt from the bracket.

How do you raise the front axle on a Jeep Cherokee?

Raise the front axle of the Cherokee with the floor jack and place the jack stand under the axle tube. Repeat for the other side to elevate the entire front suspension. Put on the safety glasses and crawl under one side of the Jeep (on a creeper if you have one) and bring the ratchet and sockets with you.

How are shocks used to soften the ride?

Shocks mount from the frame of the vehicle to the axle and absorb any bumps from the road. Shocks work in parallel with springs to soften the ride and performance. Shocks are filled with nitrogen and are specific to each vehicle. Faulty shocks can lead to premature tire wear, rough ride and poor handling.