Table of Contents
How do I reset the Dodge Ram throttle position sensor?
To reset the Dodge Ram throttle position sensor(TPS), You need to turn on the ignition without Your foot on the brake, so the engine doesn’t start. Then press the accelerator on the floor for 15 seconds. Release the accelerator. Then turn the car off and start the engine and drive.
What does the red lightning bolt mean on a Dodge Ram 1500?
The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. The light may be on for a glitch and the electronic throttle control system needs to be reset.
How much does it cost to replace a TPS sensor?
What is this? The parts will cost you between $75 and $130 on average. The labor costs will be anywhere between $60 and $90, depending on the hourly rate of the mechanics. So in total, you can expect to pay between $135 and $220 for a throttle position sensor replacement.
Where is the throttle pedal position sensor located?
A throttle position sensor (TPS) is a sensor used to monitor the air intake of a engine. The sensor is usually located on the butterfly spindle/shaft so that it can directly monitor the position of the throttle.
Can I change throttle position sensor?
How to disassemble and replace the throttle position sensor #Step 1: Disengage the throttle position sensor harness from the throttle body, located at the bottom of it. #Step2: Take out the throttle position sensor from the throttle chamber #Step 3: Use an anti-slip solution to enable easy removal from the throttle chamber, or when needed to replace it.
Is the throttle position sensor bad?
A bad throttle position sensor starts malfunctioning and relays wrong data to your car’s automated system. As a result, it usually leads to poor fuel efficiency. Knowing the signs of a bad throttle position sensor will help in quickly diagnosing the issue and making the required amendments in time.
Where is the valve position sensor located?
Usually replacing the EGR Valve Position Sensor takes care of the problem. The sensor is located on top of the EGR valve.