Table of Contents
How do you change a water pump on a Chevy s10?
Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.
Will a 4.3 water pump work on a 350?
Registered. Yes, a water pump for a small block chevy will work. A 4.3 is basically a 350 with two cylinders cut off. The water pumps should have no problems interchanging.
How much is a water pump for a 2003 Chevy S10?
Chevrolet S10 Water Pump Replacement Cost Estimate. Labor costs are estimated between $125 and $158 while parts are priced at $196.
Can I change my water pump myself?
The location of the water pump in relation to the engine can vary by application. Whether you can replace it yourself depends on how much experience you have. However, a person who easily figures out how to do things can usually replace a water pump that is on the front of the engine, without any mechanical experience.
Do you need to replace thermostat when replacing water pump?
its a good idea to replace the thermostat whenever replacing a water pump. The thermostat may have suffered some damage during the overheating that occurred before the water pump failed.
How do you know your car water pump is bad?
Here are 5 common symptoms of a bad water pump:
- Coolant Leak at the Front-Center of your Car.
- Rust, Deposit Buildup, and Corrosion of the Water Pump.
- Water Pump Pulley is Loose and Making Whining Sounds.
- Engine is Overheating.
- Steam Coming from your Radiator.
What happens when your car water pump goes out?
When the water pump fails completely, it will not be able to circulate coolant through the engine block. This results in an overheating situation and if not repaired or replaced quickly, can cause additional engine damage like cracked cylinder heads, pushed head gaskets, or burnt pistons.
Which is better short or long water pump?
Due to the longer production run, long water pumps hold the distinction of having more accessory brackets, pulleys, and other hardware available for them, but obviously the short pump will save you roughly 1-3/8-inches (1.375-inch) of room, which in a cramped hot rod engine bay might be just what you need to have your …