Table of Contents
How do you check the oil on a Yamaha Raptor 660?
The raptor 660, 700, and older YFZ450 sport quads have an oil tank sits in front of the engine. To check the oil level in these machines let the engine warm up to operating temperature. Stop the engine and allow it to sit for a few minutes. Check the oil level with the oil tank dipstick.
How much oil do you put in a Raptor 660?
Registered. the 2.43 quarts is for a completely dry engine. changing the filter and oil 2 quarts will do ya.
What oil should I run in my Raptor 660?
AMSOIL synthetic ATV lubricants are the choice of riders everywhere. AMSOIL is the Official Oil of the GNCC series. You can trust them to protect your ATV. Also, check out our customer reviews on amsoil.com to make the best choice for your Yamaha 660R Raptor.
How many quarts of oil does a 660 take?
The simple answer – 2.5 qts.
What kind of spark plug does a Raptor 660 take?
DPR8EA-9 is the standard plug that just about all of us use. You’re looking for iridium plugs. The one for the 660 is the DPR8EIX-9.
What oil does a Yamaha Raptor use?
Synthetic 10W-40 For Yamaha RAPTOR 700 2006-2021 : Automotive.
What is 10w40 oil?
The designation “10W-40” indicates a multigrade oil that is toward the low end of the SAE scale in cold weather, but at the upper end in hot conditions. 10W-40 oil is therefore good for a wide range of weather conditions.
How much oil does a 660 Yamaha Grizzly hold?
Fill the engine with 2.11 quarts of 10W40 ATV engine oil, and reinstall the dipstick.
How many cc is a grizzly 660?
Engine: It uses a four-stroke, liquid-cooled, single-cylinder SOHC engine. The forward-inclined powerplant has a bore-stroke ratio of 100 by 84 mm (3.94 × 3.31 inches). It has an engine displacement of 660 cm3, a compression ratio of 9.1:1, and a wet sump lubrication system.
How much oil does a 2005 Yamaha Raptor 660r take?
Your oil filter is on the left side of the motor and it is a screw style filter. Remove the filter last after you drained the oil. Put the oil drain plug back in and fill the oil tank up with 1 1/4 quarts of oil.
How do you drain the oil on a Raptor 660?
On the oil tank you will find the oil dip stick which is located on the top right side of the oil tank. This bolt will allow the oil from the oil tank to drain and should require a 15mm wrench or socket. (3) After removing these Two bolts allow for the oil to drain completely.