Menu Close

How do you take care of a rubber plant?

Admin

How do you take care of a rubber plant?

Rubber Tree

  1. General Care.
  2. Sunlight. Thrives in medium to bright indirect light, and can tolerate bright direct light.
  3. Water. Water every 1-2 weeks, allowing soil to dry out between waterings.
  4. Humidity. Any humidity level will do.
  5. Temperature. 65°F-85°F (18°C-30°C).
  6. Size.
  7. Common Problems.
  8. Precautions.

When should I feed my rubber plant?

Feeding. To produce those massive leaves the Rubber Plant needs feeding. Little and often is best, a weak balanced feed every couple of watering’s during Spring and Summer. As with usual feeding rules, don’t fertilise in Winter, or recently repotted and new plants for a good 3 to 6 months.

How do I make my rubber plant bushy?

Pruning A Rubber Plant to Promote Bushiness

  1. Step 1: Make a plan. Step back and observe your rubber plant.
  2. Step 2: Remove any branches which seem out of place.
  3. Step 3: Cut to your desired height.
  4. Step 4: Encourage leaf coverage by pruning often.
  5. Step 5: Propagate new cuttings back into the pot.

Do rubber plants need a lot of water?

Rubber plants’ water needs vary according to season: In the growing season (summer), the plant should be kept moist. This includes wiping the leaves with a damp cloth or even misting them. During the dormant season, your plant may only need water once or twice a month.

Why does my rubber plant keep dropping leaves?

Light Change – A common reason for a rubber plant losing leaves is a change in the light. Humidity – Rubber tree plants need higher humidity. Houses can be dry, especially in the winter when the heat is on. This lack of humidity can cause leaves falling off rubber tree plant.

Can you keep a rubber plant outside?

If you live in zones 10 through 12, you can also grow rubber plants outside in both sunny and shady areas. Rubber trees growing outdoors in rich, well-draining soil can get pretty big (20 to 30 feet tall), so be sure to plant them they can spread out a bit—or plan to prune them.

What is best fertilizer for rubber plant?

Fertilize the rubber tree with a 10-10-10 nitrogen, phosphorous, potassium slow-release granular fertilizer beginning in the spring, after active growth begins. Apply the fertilizer at a rate of 1 tablespoon per square foot of soil.

Which fertilizer is best for rubber?

Rubber plants need a high phosphorus fertilizer at their early growth stage as it facilitates healthy root growth. As the rubber plant mature, you must use an NPK fertilizer of 24:8:16 ratio to stimulate rapid and bushier growth.

How do you save a dying rubber tree plant?

Solution: Just when you realized that your plant needs less water and more space to breathe, do as follows : Stop watering it for some time until the soil is dry up to 1 inch. Cut the dead leaves. Let it breathe….Overwatered rubber plant

  1. The leaves turn yellow.
  2. Leaves start shedding.
  3. Attract pests.
  4. Root rot.

Why is my rubber plant dying?

The main reasons why your rubber plant might be dying are a change in light conditions, over or underwatering, dry air and pests.

How do you fix a sagging rubber plant?

Leaf droop – over or underwatering

  1. Cause – most likely underwatering, but could also be overwatering.
  2. Remedy – always check the soil before watering a Rubber Tree. It should be dry to the touch before watering again. If you suspect it’s been overwatered, allow soil to dry out completely before watering again.