How do you wind a clock without a key?

How do you wind a clock without a key?

If your clock has functional hanging weights and a pendulum, you won’t need a key for winding your clock. Instead, you’ll need to raise the weights using the special crank that comes with the clock. While you’re cranking the weights up to wind the clock, take care not to lift the weights by hand while doing so.

Are clock keys universal?

Which type of key would suit my clock? The style and design of a particular key means it will not always be suitable for every clock. Mantel clocks & French clocks will use either a standard Brass butterfly key or Steel bow type key.

Are grandfather clock keys universal?

The universal 5 way clock key allows for the replacement or back up of original clock keys that are often lost with older antique, grandfather clocks. The odd sizes (see key sizing chart below) are 5 of the most popular key sizes manufactured into 1 universal key.

How do you wind an old clock with a key?

Insert the key or crank into a winding point. Hold the clock steady with your nondominant hand and use your other hand to turn the key or crank clockwise, instructs Antique and Vintage Clock. If it won’t turn clockwise, your clock winds counterclockwise, so turn the key or crank the other way.

How do you wind a 3 hole clock?

3) Winding the clock To wind the clock use the enclosed key. Turn key clockwise until it stops (about 3 1/2 turns on the left winder and about 4 1/2 turns on center and right winder. The center winder is for the timekeeping, the right winder is for the quarter-hour chime, and the left winder is for the hour strike.

How do I know what size clock key I need?

On the back of your clock is the winding arbor (the steel shaft the key fits on to). With your digital gauge, measure the square shaft from flat side to flat side to get the millimeter size. Most winding arbors taper out towards the the clock and the end section is most likely the smallest.

Do all Howard Miller grandfather clocks use the same key?

Brass finished door key with Howard Miller logo, fits most standard floor clocks. These are made only for Howard Miller grandfather clocks with a model number prefix of 610 or 611 (except for Presidential Models) and clock must have been made since 2001.

How do you size a clock key?

What kind of Keys do you need to open an antique clock?

Barrel Key & Clock Keys Lost the key to your antique clock or cabinet door? Try one of our decorative and fully functional barrel keys or clock keys. Suitable for cabinets, furniture drawers, desks and armoirs, these standard keys will open many old locks.

What kind of key do you need to wind a clock?

Key size are often confusing enough on the single end styles before adding another end to the confusion. offering a 4 pack of steel double end keys that are the most common combination of sizes. One end of the key will wind the clock. This door key fits most modern clocks such as Howard Miller and others.

What kind of key do I need to open an antique cabinet door?

Lost the key to your antique clock or cabinet door? Try one of our decorative and fully functional barrel keys or clock keys. Suitable for cabinets, furniture drawers, desks and armoirs, these standard keys will open many old locks.

How to find the right key for Your Clock?

Of course, it can be tricky to find the right key for your clock because there are many sizes. The Clock key size chart will give us the right size key to order. In addition, some keys have two sizes on one key and this is called a double end key.