How does the clutch safety switch work?
The clutch safety switch prevents the engine’s starter motor from cranking the engine unless the driver applies the clutch pedal. This eliminates the chance of cranking the engine with the transmission in gear, which could cause sudden vehicle movement, especially if the engine starts.
How much does it cost to replace a clutch safety switch?
Replacement Cost Having the neutral safety switch replaced can cost anywhere between $100 and up to around $350 for both parts and labor, depending on the make and model of your vehicle, as well as the type of specialist working on the system.
What can a bad clutch switch cause?
The clutch safety switch is designed to close and provide electricity when the pedal is depressed. However, if the switch fails, it will not be able to provide power for the starting circuit. This will lead to a vehicle that does not start when the key is turned, even if the pedal is depressed.
How do you install a new clutch switch?
Remove the clutch switch from the clutch pedal bracket. Step 1: Install the switch. Put the adjusting nut on the new clutch switch and install the switch into the clutch pedal bracket.
How can I tell if my clutch switch is failing?
There are two ways to determine if the clutch switch is failing or has failed. First, the contacts inside the clutch switch have corroded or burned and will not make a connection to complete the circuit from the clutch switch to the ignition switch.
What should I use to clean my clutch switch?
If your clutch switch wire harness has a plug, then remove the plug and check the contacts inside for corrosion and moisture. If there is moisture currently present, you need to spray an electrical cleaner onto the contacts. If there is corrosion in the plug, you need to use baking soda and water to clean out the corrosion.
How does the clutch switch work on a car?
Clutch switches are designed to keep the vehicle from starting in gear. When the clutch pedal is in the up position, the clutch switch is normally open with no power to the ignition switch. When pushing down on the clutch pedal, the clutch switch closes the circuit to the ignition switch allowing the starter to the engine to engage.