Table of Contents
How long does it take to replace airbag module?
The repair work is expected to take about 2 hours to complete, depending on dealer schedules. While repair times can vary from 1 to 2 hours, wait times might be longer depending on dealer schedules.
Can I start my car without the airbag module?
While a vehicle can still run without an airbag module, it is strongly recommended that drivers do not operate the vehicle without it being installed—unless an emergency situation arises and there is no other option. Without airbags deploying, a driver and any passengers can face severe injury or even death.
How much does it cost to replace an airbag module?
The average cost for an airbag control module replacement comes between $685 and $712 for most cars and locations. The labor costs for this procedure are estimated between $103 and $130, while the cost of the parts is more expensive at $582.
Can you replace an airbag module?
If there is an airbag deployment, it will need to be replaced with a new or used airbag. Airbags are not repaired and not repacked. The airbag control module however can be reset to clear crash history and then can be used again instead of purchasing a new airbag control module.
Where is the airbag control module located in a car?
To remove your airbag control module, follow these steps: First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
Where are airbag codes stored in a Chevy?
Below you will find common airbag codes that can be stored in your airbag control module after your vehicle was in an accident. The best part of having your Chevy’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play.
How to remove the SRS airbag control module?
To remove your airbag control module, follow these steps: 1 First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. 2 Disconnect the positive battery cable and wait 3 min. 3 You are now safe to unplug the airbag control module harness wiring plugs.
Can a Chevy airbag be reset by myairbags?
The best part of having your Chevy’s original airbag module reset by MyAirbags is that when you get your airbag control module back and it goes back into the same vehicle that it came out of then it will be plug-n-play. No additional programming of the VIN is required to fix your airbag codes.