What are the 3 classifications of faults?

What are the 3 classifications of faults?

Different types of faults include: normal (extensional) faults; reverse or thrust (compressional) faults; and strike-slip (shearing) faults.

Which of the following are the classifications of faults?

Any of these four types of faults (bedding, strike, dip or oblique faults, may be either normal or reverse faults.

What are the four classifications of faults?

There are four types of faulting — normal, reverse, strike-slip, and oblique. A normal fault is one in which the rocks above the fault plane, or hanging wall, move down relative to the rocks below the fault plane, or footwall.

Which type of fault is shown?

The type of fault that is shown is a reverse fault. The hanging wall block lies on the left, and the footwall block lies to the right. The footwall block has moved downward relative to the hanging wall block. Thus, this fault is a reverse fault.

How are faults classified in power system?

Faults in overhead transmission system can be classified into two types, i.e. series (open conductor) faults, and shunt (short circuit) faults. Series faults can be identified easily by observing the each phase voltage. Short circuit faults are divided into two types, i.e. asymmetrical faults, and symmetrical faults.

Which one is not a classification of faults?

Explanation: The various faults under apparent movement as basis are, normal faults, reverse faults, hinge faults and strike-slip faults. Strike faults is not studied under this basis.

What is a fault in geography?

A fault is a fracture or zone of fractures between two blocks of rock. Faults allow the blocks to move relative to each other. Most faults produce repeated displacements over geologic time. During an earthquake, the rock on one side of the fault suddenly slips with respect to the other.

Which type of fault is shown quizlet?

The type of fault that is shown is a reverse fault.

What are the two fault classification?

Faults which move along the direction of the dip plane are dip-slip faults and described as either normal or reverse (thrust), depending on their motion. Faults which move horizontally are known as strike-slip faults and are classified as either right-lateral or left-lateral.