Menu Close

What is fault 49 on Fisher and Paykel Aquasmart?

Admin

What is fault 49 on Fisher and Paykel Aquasmart?

@stevew Error Fault Condition – Water Inlet Valve Fault. Repair or Check – Unplug the washer from power. Reconnect any non secure wires on the water inlet valve. Replace the wire harness if it is found to be damaged.

How do I put Fisher and Paykel into diagnostic mode?

DIAGNOSTIC MODE

  1. Turn the power on at the power point but off at the machine.
  2. Press and hold WASH TEMPERATURE SETTING DOWN and then press POWER until the. machine gives 2 short beeps and lights up.
  3. Release the buttons after the beeps as the beeps indicate diagnostic mode has been entered.

What is the fault code for the Fisher and Paykel washing machine?

Check for water leaks out of the drum. Fisher and Paykel Washing Machine Fault 37 – Drain Pump Fault Problem: This is one of the most common Fisher and Paykel washing machine fault codes. Fault 37 appears when the water has not drained from the drum.

How does the Fisher and Paykel AquaSMART washer work?

In the High Efficiency mode the AquaSmart™then fills with just enough cool water to lift the clothes off the low profile agitator so when it rotates, the clothes gently roll over each other. This wash gives you the benefit of water savings, using similar quantities of water to most front loaders.

What to do if spin basket on Fisher Paykel washer is not working?

Measure the resistance of the lid lock using a volt/ohm meter. If the resistance isn’t 63 ohms, replace the lid lock assembly. If the resistance is correct, replace the motor control module. The spin basket must be able to rise and fall with the water level to engage and disengage from the clutch. Unplug the washer and pull out the spin basket.

Is the Fisher Paykel washer a good washer?

At the same time, the home appliances of this model are highly reliable and have a high capacity, which makes them very convenient for users. If you experience some problems with your Fisher Paykel washer, don’t rush to call the service center – there’s a possibility that you can handle the issues on your own within a few minutes.