What is the front hub bearing torque specs?
The torque specifications for GM wheel hubs generally range between 107 to 225 foot-pounds, depending on the year and model.
How tight should you tighten a wheel bearing nut?
The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off slightly, about maybe a 1/8 of a turn.
How do you torque front wheel bearings?
Torquing the Wheel-Bearing Nuts on Front Non-Drive Steer Axles. Torque the inner nut to 100 foot-pounds with a torque wrench and a socket for the initial adjustment. Back off of the inner nut one complete turn. Turn the hub in a clockwise direction with your hands to free up restrictions from the wheel bearing.
Can you over tighten wheel bearings?
Once greased up and put back into place, wheel bearings need to be tightened in a very specific way. If this is not done properly, they can become too tight and that will cause excessive wear to the bearing itself, ultimately causing it to fail.
How do you tighten a hub bearing?
How to Tighten Wheel Bearings
- Tighten the bearing for the first time.
- Loosen the nut back to where you can turn it with your fingers.
- Tighten the nut to where it is tightened firm once again.
- Loosen the nut to where you can once again turn it with your fingers.
What is the torque spec for CV axle?
What is the torque spec for CV axle? Final torque (weight of vehicle on wheel) should be 265 Nm (195 Ft Lb) if using thread locking compound or initial torque + 1/4 turn if greased. Also, manual says nut or bolt should always be replaced.
What is the torque specs for a axle nut?
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200 ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of 300 ft-lbs.