Table of Contents
What kind of pipe do you use for a shallow well?
Suction pipe can be Schedule 80 PVC, poly pipe or threaded and coupled galvanized pipe. Approved plastic pipe is lighter and much easier to install in shallow wells. Exposed pipe should be galvanized steel – it is more resistant to freeze damage and considerably more durable than PVC.
How much does a 100 foot well cost?
Well Drilling Cost
| Depth In Feet | 4” Diameter PVC Casing | 6” Diameter Steel Casing |
|---|---|---|
| 100 | $3,550 | $6,120 |
| 150 | $5,325 | $9,180 |
| 200 | $7,100 | $12,240 |
| 250 | $8,875 | $15,300 |
Does a shallow well need a casing?
Shallow dug wells typically extend no farther than 30 feet. Drilled wells, typically 8 to 10 inches in diameter, require casing to reduce the contamination from the ground’s surface or surrounding strata.
Can you use PVC for a well?
PVC is a perfectly viable material for well construction, but it helps to know its limitations. A lot of drillers (probably more than half) use PVC casing for most of their domestic wells. It is inexpensive, reliable, never rusts and, used within limits, will make a lifetime well.
What is well casing pipe?
Casing provides support for the wall of the well so that loose rock fragments or unconsolidated sand and gravel through which the well has penetrated do not collapse into the well shaft. The casing protects the electrical wires, pull cable and water tubing/piping that are connected to the submersible pump.
How to install a drive point for a well?
DRIVE WELL POINT INSTALLATION INSTRUCTIONS DRIVE COUPLING 2 Attach a length of pipe to the point using a drive coupling. Place the drive cap over theopen end of the pipe. Always use two wrenches turning in opposite directions. DRIVE CAP CAUTION: DRIVE ONLY WITH DRIVE CAP ON! 6 NOTE: Determine the depth of water table before beginning. Water
What’s the best way to drive a well?
A 100-pound “slam-hammer” drives the well point and pipe down to the water table. The first several gallons of water from your well will be muddy, until loose soil is pumped away to leave a cavity filled with clear water.
How big of a hole do you need for a driven point well?
Rent or borrow a post hole digger, a pipe driver and a hand pump (pitcher pump) if you do not have these items already. Use the post hole digger to augur a starter hole where you want the well to be located. The hole only has to be 3 to 4 feet deep before you can start driving pipe down.
How do you fill a well with water?
Prime the pump to create suction for its vacuum cylinder by pouring a cup of water into the pump’s top, and jack the handle until water spurts from the pump with each downstroke. To be sure the well point is fully immersed in water, remove the pump, replace the cap, and hammer the pipe another two feet.