Table of Contents
When did Epiphone start using truss rods?
By 1934-35 , a ” patented expansion truss ” was standard on all upper line Epi necks . A patent application was filed by Epi on Aug 2 ,1937 and was granted on Feb 28 , 1939 . After then it was called the ” exclusive and patented Epiphone Thrust rod ” in catalogues and was standard on all archtops .
Do all acoustic guitars have truss rods?
All electric guitars and almost every steel-string acoustic will have a truss rod. Since nylon strings create a lot less tension, they don’t always have a truss rod in the neck.
Does my guitar have a truss rod?
You can tell if a guitar has a truss rod by checking at either end of the neck for either a truss rod cover or direct access to the truss rod. Acoustic guitars typically provide access to the truss rod through the sound hole, but some provide access on the headstock, so check both areas on your guitar.
How do I know if my truss rod needs adjusting?
Two primary signs tell you that your truss rod needs adjusting:
- There’s a noticeable change in the action; the height of the strings over the frets has become either too high or too low.
- Some strings buzz on the frets between the nut and the fifth fret.
Where is truss rod on Epiphone acoustic?
The truss rods on most Epiphone electric guitars are accessible in the headstock directly above the nut. The truss rods on Epiphone acoustic guitars are accessible through the sound hole where the neck joins the body of the guitar.
What size is an Epiphone truss rod?
It’s most likely a metric size and either 5mm or 7mm (most common).
How do I find the truss rod?
A truss rod is a thin metal shaft that runs the length of the guitar’s neck from the nut to the heel, where the neck joins the body. It sits just under the fretboard and can be accessed through a small hole behind the nut on most guitars, which is usually covered by a small piece of wood or plastic held down by screws.
Can you adjust the truss rod with strings on?
You can adjust the truss either way, with the strings tuned to pitch or downtuned. Just be sure to retune it to the correct pitch once you make the adjustment. Also, put a drop or two of some light machine oil onto the threads where you’ll be turning the truss.
Where is the truss rod on a guitar?
neck
The truss rod is component of a guitar or other stringed instruments that stabilizes the lengthwise forward curvature (also called relief), of the neck. Usually it is a steel bar or rod that runs inside the neck, beneath the fingerboard.
Does my Martin have a truss rod?
Martins do not have the truss rod adjustment under a cap on the headstock. About a year ago, Martin switched to a new, two-way truss rod. The new truss rod is located in the same place as the truss rod has always been but the adjusting nut is farther up the inside of the neck than it used to be.