Menu Close

Why is my security light blinking?

Why is my security light blinking?

The blinking light indicates that a car has an electronic security system. Incidentally, the reason this is added is to enhance the deterrent to theft effect of the security system — that is to say, the light is designed to further discourage attempted theft.

How do you reset the anti theft system?

Exit the car with all doors closed and the windows rolled up. Also close and any rear doors such as the trunk, rear hatch and front hood. Lock the car using the drivers side lock and walk away from the car at least ten feet. Wait for fifteen minutes and unlock the door, this should reset the security system.

What does the security light on my dashboard mean?

The security Warning Light is located on your instrument panel. When the security Warning Light is illuminated, that means that the theft-deterrent system may not be working properly. Tip Like all warning lights, the security Warning Light will briefly illuminate when your vehicle is turned on.

How do you reset a motion sensor light?

Some motion detector lights are wired to a wall switch, often found in the garage or near an entry point. Here’s how to use the wall switch to reset your lights: Step 1: Turn your light switch to the on position, then flip it off for two to three seconds. Turn the switch on and check your lights. If this does not work, proceed to step two.

How to reset an automotive security alarm system?

Call to the dealer, this was their response: Disconnect the battery for one minute and then reconnect the battery this should reset the immobilizer system. To disarm the alarm system press the unlock button on the key fob. Cadillac Chevy GMC and Other GM Security Reset

How do I deactivate the security system on my car?

Then hit the unlock button on the fob twice this should deactivate the security system which should be accompanied by exterior lights flashing or an audible horn beep. Each of these steps should be followed by the cancellation of the security light.

How can I Reset my Volkswagen security system?

Volkswagen Security System Reset. To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.