Table of Contents
Can you replace just the throttle position sensor?
When a throttle position sensor goes bad, your vehicle may stall or run rough at idle, and may stumble upon acceleration. The replacement of the TPS is a straightforward procedure that should take an amateur mechanic less than an hour to complete.
How much does it cost to replace a throttle position sensor?
The average replacement cost for the throttle position sensor is anywhere from $110 to $200. The parts cost is anywhere from $75 to $105 while the labor cost is anywhere from $35 to $95. In addition, you will have to account for any extra fees and taxes that get added on as well.
How do you install a throttle position sensor?
How to Replace a Throttle Position Sensor
- Materials Needed.
- Step 1: Locate the sensor.
- Step 2: Disconnect the negative battery cable.
- Step 3: Remove the sensor electrical connector.
- Step 4: Remove the sensor mounting screws.
- Step 5: Remove the sensor.
- Step 1: Install the new sensor.
How do you remove a throttle position sensor?
Your throttle position sensor should be attached using electrical connectors. These connectors are easy to remove using the tab on the side. Once the electrical connectors are removed, look for the mounting screws on your sensor. Carefully unscrew and remove your throttle position sensor.
Does a throttle position sensor need to be programmed?
Code errors can cause your throttle position sensor to work erratically or incorrectly. Otherwise, you’ll need professional software to reprogram your sensor. This job is best done by a professional mechanic. If your sensor just needs repairs, it could be the result of faulty or loose wiring.
What do I do if my car wont start after I change the throttle position sensor?
You probably just need to adapt the throttle body, or the battery is not connected properly. Turn the car to ON, press the accelerator to the floor, wait one full minute, let it up, wait a full minute, turn the car to off and remove the key.