Table of Contents
- 1 What size is f150 drain plug?
- 2 How much fluid does a M5OD take?
- 3 What size socket do I need to change transmission fluid?
- 4 What size is the oil drain plug on a 2001 Ford f150?
- 5 How do I identify a NP435 transmission?
- 6 What size nut is the oil plug?
- 7 When did Ford start using the M5R2 transmission?
- 8 What kind of transmission does a Ford M5OD have?
- 9 When to change transmission fluid on Ford F-150?
What size is f150 drain plug?
Dorman – Autograde – Oil Drain Plug Standard M14-1.50, Head Size 17mm (Part No. 090-033.1)
How much fluid does a M5OD take?
Mazda M5OD-R2 Transmission Specs
| Transmission: | Mazda M5OD-R2 (M5R2, Mazda R2) |
|---|---|
| Max Input Torque: | N/A |
| Weight: | ~ 115 lbs |
| Fluid Type/Spec: | MERCON V ATF (Motorcraft XT-5-QMC) (MERCON V replaces the now defunct MERCON ATF) |
| Fluid Capacity: | 7.6 pints, 3.8 qts (U.S. quarts) total capacity |
What did the M5OD come in?
The M5OD-R1 is a fully synchronized five speed manual transmission produced by Mazda. The transmission was first introduced for the 1988 model year in the Ford Ranger, Bronco II, and Aerostar. The transmission would be available in the Ford Ranger until its retirement following the 2011 model year.
What size socket do I need to change transmission fluid?
It looks like a breaker bar with an adaptor that would be used to connect 1/2” drive tools to 3/8” sockets. The drain plug is simply a 3/8” square so any extension with a 3/8” inch square will work. You don’t need a special tool.
What size is the oil drain plug on a 2001 Ford f150?
Notes: AutoGrade – (Carded), M14 x 1.50 Thread size. SAE/Metric 21 Head size. 0.6″ Shank Length.
What size is the oil drain plug on a 2002 Ford f150?
16mm
Dorman – Autograde – Oil Drain Plug Pilot Point M14-1.50, Head Size 16mm (Part No.
How do I identify a NP435 transmission?
Identification: You can recognize the NP435 by it’s single piece, aluminum, bolt-on top cover with the shifter sticking directly out of the top and a fitting on the driver’s side for the back up light switch. Most have the letters “NP” inside a circle cast into the cover.
What size nut is the oil plug?
Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.
How many quarts does a 2010 f150 5.4 hold?
7 quarts
Engine Oil
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 7 quarts. (with filter)After refill check oil level. |
| Torque: | 17 ft/lbs (Oil Drain Plug) |
When did Ford start using the M5R2 transmission?
The M5R2 transmissions were used by both Ford and Mazda in Broncos and F series pickup trucks starting in 1988 The M5R@ is a top loaded all aluminum 5 speed transmission with an integrated bell housing and shift tower. This transmission is a fully synchronized unit with all brass synchronizer rings in all gears.
What kind of transmission does a Ford M5OD have?
Description The M5OD is a top-shift, fully-synchronized, five-speed manual transmission (7003), equipped with an overdrive fifth gear ratio. All gear changes (including reverse) are accomplished with synchronizer sleeves. The case (7005), case cover (7222), and extension housing (7A039) are constructed of aluminum alloy.
What kind of bearing does a M5R2 transmission have?
This transmission is a fully synchronized unit with all brass synchronizer rings in all gears. This transmission has a tapered front input shaft bearing that is 90mm OD. The M5R2 has a cast iron rear bearing retainer. Three rubber plugs are used on the shift tower.
When to change transmission fluid on Ford F-150?
Although the factory doesn’t require the transmission fluid to be replaced except for at every 60k miles, when your Ford F-150 starts racking up the miles, replacing the fluid more often is a great way to protect the transmission.