What would cause no injector pulse?

What would cause no injector pulse?

The nature of the cause of no injector pulse is that there is no power input. The three main factors that lead to that condition are blown injector fuse, bad injector electrical relay, and bad wiring. If the fuse and relay are normal, you will need to check the cylinder without the injector pulse.

Will a bad crank sensor cause no injector pulse?

The crank sensor can cause no spark and no pulse to the injectors, however, it would be the ground side of the injector harness that was missing. You should still have 12v at the harness.

What controls the injector pulse?

The (PCM) uses the trigger signal from the crankshaft position sensor; and/or camshaft position sensor to pulse the injectors.

Does crankshaft position sensor control injector pulse?

Crank Position Sensor, does control injector pulse AND ignition spark. Often these little buggers become intermittant. A little tap with a spanner will usually bring the sensor back online, but suggest to replace it ASAP.

What are the symptoms of a failing crank sensor?

Symptoms of a Bad Crankshaft Position Sensor

• Your Check Engine Light is Blinking.
• It’s Difficult to Get Your Vehicle to Start.
• Your Vehicle is Stalling and/or Backfiring.
• The Engine is Making Your Vehicle Vibrate.

What causes no power to fuel injector pulse?

Ans: The engine control unit is the electronic brain that used to control the fuel injector pulse by gathering data from various sensors along the fuel line Question: What causes no power to fuel injectors? Ans: The problem may be a blown injector circuit fuse or a fault in the wiring harness to the injector or a bad fuel injector power relay.

How does the fuel injector work in a car?

What is Fuel Injector? The injector in a basic picture is an electronically controlled valve that is supplied with pressurized fuel from the fuel pump at a certain pressure level injector can be electromagnetically opened and closed at very high speed—this speed controlled by the electronic control unit using.

How do you test a fuel injector ( ANS )?

Ans: By using a simple diagnostic tool called NOID light, this tool detects a digital signal coming from the ECU and flashes an LED light, so if there is no LED flashing during cranking, this means that there are no pulses coming out of the ECU. Question: How do you test a fuel injector?

How to check a blown fuse in RX?

To check a blown fuse you have to pull the fuse out of its place and check it by seeing the internal wire to see its continuity if you see it cut you have to change it with a new one with the same value, also try to swap the relay with another same value relay and try.

https://www.youtube.com/watch?v=3HVa-RpOPbs