Table of Contents
How much does it cost to replace a turbine speed sensor?
VSS Replacement The DIY cost for replacing a speed sensor is the cost of the sensor. Depending on the vehicle year, make and model, a speed sensor can cost as little as $7.92 or as much as $100. For most vehicles, the cost for a speed sensor is between $25 and $45.
How much is a turbine speed sensor?
Labor costs are estimated between $106 and $133 while parts are priced between $144 and $162.
What is a turbine speed sensor?
The input/turbine speed sensor is used to measure how many revolutions per minute (RPM) the input shaft of the transmission is turning. It is usually a three-wire sensor that reads a reluctor ring in the transmission.
How do I fix error code P0715?
What repairs can fix the P0715 code?
- Replacing the input speed sensor.
- Repairing damaged wiring for the input speed sensor.
Where is the speed sensor on a Ford?
Slide under the vehicle and locate the speed sensor. On a Ford transmission, the sensor is located on the driver side of the transmission, toward the rear of the unit. The sensor is a magnetic unit that screws into the transmission and has an electrical connector plugged into it.
How do you install a new speed sensor?
Install the new speed sensor. Place the sensor into the appropriate spot on the transmission. Secure the sensor by twisting it clockwise with the wrench until the sensor cannot be twisted any more. Plug the electrical connector into the new sensor until it clicks into place.
When to replace a Ford transmission speed sensor?
If you notice your speedometer begins to jump around, or does not work at all, the speed sensor should be replaced immediately. Replacing the speed sensor requires just a few tools. Park the Ford vehicle on a level surface and allow the vehicle to cool for 30 minutes.
Where is the transmission sensor located on a Ford Focus?
On a Ford transmission, the sensor is located on the driver side of the transmission, toward the rear of the unit. The sensor is a magnetic unit that screws into the transmission and has an electrical connector plugged into it. Refer to your owner’s manual, if needed. Remove the electrical connector.