What is another name for a groove in woodworking?

What is another name for a groove in woodworking?

Rabbet – a notch cut with or across the grain on the edge of a board with the two sides 90º to each other. Dado – a square or rectangular slot that runs across the grain. Groove – a square or rectangular slot that that runs with the grain.

What is the purpose of groove?

In manufacturing or mechanical engineering a groove is a long and narrow indentation built into a material, generally for the purpose of allowing another material or part to move within the groove and be guided by it. Examples include: A canal cut in a hard material, usually metal.

What are carpentry grooves called?

Some cabinetmakers differentiate between groove and dado joints, insisting that grooves are cut with the grain, dadoes across. Whatever you want to call them, grooves or dadoes are cut easily with a dado head on a radial arm or table saw.

What is a groove joint?

A tongue and groove joint is a unique woodwork joint that is attached edge to edge with two or more pieces of timber. It is made with one edge consisting of a slot that runs down the entire length of the timber and a tongue which fits into the slot.

Is it tongue in groove or tongue and groove?

Tongue-in-groove is similar to tongue and groove, but instead of the tongue forming part of one of the edges, it is a separate, loose piece that fits between two identically grooved edges.

What do you mean by groove?

1 : a long narrow channel or depression. 2a : a fixed routine : rut. b : a situation suited to one’s abilities or interests : niche. 3 : top form a great talker when he is in the groove. 4 : the middle of the strike zone in baseball where a pitch is most easily hit a fastball right in the groove.

What does grooving mean?

Noun. 1. grooving – the cutting of spiral grooves on the inside of the barrel of a firearm. rifling. formation, shaping – the act of fabricating something in a particular shape.

What is the difference between a groove and a dado?

The only difference between a groove and dado is grain orientation. While a dado runs across the grain, a groove runs with the grain as shown in Figure 4. You can cut grooves with a straight bit and edge guide using a hand-held router, or a straight bit in a router table.

Is tongue and groove stronger?

A tongue-and-groove is stronger than simple butt joints due to the increased gluing surface and mechanical interlocking of the two mating pieces. As a bonus, the tongue also serves to perfectly align the workpieces during the glue-up for a smooth surface.

Is shiplap cheaper than tongue-and-groove?

Shiplap is cheaper than tongue and groove, but it requires a bit more work on the carpenter to get the rows to lay flat against the building in a waterproof fashion. Also, if not installed properly, shiplap is more likely to warp and leak than its counterpart.

What is better shiplap or tongue-and-groove?

As a general rule, shiplap is the better choice for a very rainy climate, as its overlapping planks shed water quite well. Tongue and groove, on the other hand, can deteriorate in wet climates due to trapped water inside the interlocking connections.