Menu Close

How much is a wheel bearing for a Chevy Silverado?

How much is a wheel bearing for a Chevy Silverado?

Chevrolet Silverado 2500 HD Wheel Bearing Replacement Cost Estimate. Labor costs are estimated between $175 and $221 while parts are priced between $301 and $422.

How long can you ride on a bad wheel bearing?

To avoid this situation, it is recommended to drive at the slower speed so that your wheel stays in action a few more hours. SO, while thinking how long can you drive on a bad bearing? You should not go more than 1000 miles as it might result in some bigger issue.

How long does a wheel bearing replacement take?

90 to 120 minutes
How long does it take to replace Wheel Bearings? Replacing a single wheel bearing can take 90 to 120 minutes depending on the type of vehicle and complexity. There are a lot of moving parts that need to be maintained and properly sealed to complete this type of work.

How much does it cost to replace wheel bearings on a trailblazer?

On average, the cost for a Chevrolet Trailblazer Wheel Bearings Replacement is $324 with $200 for parts and $123 for labor. Prices may vary depending on your location. What are wheel bearings and how do they work?

How do you replace the wheel bearing on a car?

Finally, the brake rotor and brake caliper are re-attached, the wheel installed and the car is road tested. On vehicles where the wheel bearing is pressed into a cavity within the steering knuckle, the steering knuckle must be removed from the vehicle in order to press out the old bearing and press in the new bearing.

Where can I get bearings replaced on my Saturn?

The old bearings are removed and replaced with new units and then reassembled. A certified mechanic at your dealership service department or at a local automotive repair center can do the replacements.

Why are my wheel bearings not working properly?

Tire and wheel assembly does not turn smoothly. With the wheel jacked up, and the car not in gear, the wheel should rotate smoothly. Rough or inconsistent movement, which is often accompanied by noise, can signify damaged bearings.