Menu Close

Where do you jack up a Subaru Forester?

Where do you jack up a Subaru Forester?

It should be towards the rear of the car past the oil pan. Lifting it on up! Once you have the vehicle lifted to a proper height for your repair, you can place the jack stands.

Can you put jack stands on control arms?

Its not a safe idea to place the jack stand on a control arm as a lift point because the control arm moves, and the mounting point may shift on you. The jack stand may shift and the car will fall off of the stand.

Can you jack up only one wheel?

Depending on the job at hand, you might need to lift just one wheel, the front end or back end, or the entire car. Assemble your lifting and supporting gear. If lifting just one end of your car, you’ll need two jack stands. If you’re lifting the entire car, use four jack stands.

Where are the Jack points on a Subaru Forester?

Subaru Forester Rear Jack point. (Just below the two bolts in the center of the picture) The rear differential will flex when you jack on it. If you have an after market hitch you get to cheat. If you have a fat cow of a floor jack like I do you will want to jack up the front of your car first.

Can you jack up a Subaru Forester at home?

Subarus are straightforward to jack up, but if you have never done it before or you just don’t want to screw something up on your car then this post is for you. Using the provided jack points and few jack stands it is possible to rotate your tires and do an oil change on the forester in a few short minutes at home.

Can you rotate the tires on a Subaru Forester?

Using the provided jack points and few jack stands it is possible to rotate your tires and do an oil change on the forester in a few short minutes at home. If possible you should rotate your tires every oil change.

Where do you put the jack stand on a Subaru?

Once you have the vehicle lifted to a proper height for your repair, you can place the jack stands. For the front end of the car you can use the reinforced pinch welds that will hold the weight easily. If you are working on that part of the car you can use the inner unibody frame rails.