Table of Contents
- 1 How do I find my router administrative distance?
- 2 How do I set administrative distance?
- 3 What command can be used on a Cisco router to view the routing table quizlet?
- 4 Which command displays our IP routing table?
- 5 What’s the default administrative distance for a router?
- 6 How to change the administrative distance of a routing protocol?
How do I find my router administrative distance?
You can display the administrative distance of all routes on your router by typing the show ip route command:
- In the case above, the router has only a single route in its routing table learned from a dynamic routing protocols – the EIGRP route.
- Metric.
- RIP has been configured on all routers.
How do I set administrative distance?
To set an administrative distance:
- For RIP and OSPF, issue the distance command in Router Configuration mode. host1(config-router)#distance 100. The range for administrative distance is 0–255.
- For IS-IS, issue the distance ip command in Router Configuration mode. host1(config-router)#distance 80 ip.
What is administrative distance in routing explained *?
Administrative Distance (AD) is a value that routers use in order to select the best path when there are two or more different routes to the same destination from two different routing protocols. Administrative Distance counts the reliability of a routing protocol.
What is administrative distance in networking?
What command can be used on a Cisco router to view the routing table quizlet?
show ip route The ip route command is used to display the routing table of a router. would you expect to see next to this route? a /32 prefix defining a route just for the one address. You just studied 19 terms!
Which command displays our IP routing table?
The debug IP rip command
Which command displays RIP routing updates? Explanation: The debug IP rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.
How do I display routing table?
To display the kernel routing table, you can use any of the following methods:
- route. $ sudo route -n. Kernel IP routing table. Destination Gateway Genmask Flags Metric Ref Use Iface.
- netstat. $ netstat -rn. Kernel IP routing table.
- ip. $ ip route list. 192.168.0.0/24 dev eth0 proto kernel scope link src 192.168.0.103.
What is administrative distance CCNA?
The administrative distance (AD) is a number used to rate the trustworthiness of the routing information received from a neighbor router. It is used when a router must choose between routes learned using different routing protocols. Each routing protocol has a default AD value.
What’s the default administrative distance for a router?
For example, if a router receives a route to a certain network from both Open Shortest Path First (OSPF) (default administrative distance – 110) and Interior Gateway Routing Protocol (IGRP) (default administrative distance – 100), the router will choose IGRP because it is more reliable.
How to change the administrative distance of a routing protocol?
You can modify the administrative distance of a protocol using the distance command in the routing process subconfiguration mode, which specifies that the administrative distance is assigned to the routes learned from a particular routing protocol.
What should the administrative distance be for Rip routes?
It shows that the RIP routes are preferred. They are learned with an administrative distance of 90, although the default is 120. Note that the new administrative distance value is relevant only to the routing process of a single router (in this case R1). R2 still has IGRP routes in its routing table.
When do I need to use administrative distance command?
This command specifies that the administrative distance is assigned to the routes learned from a particular routing protocol. You need to use this procedure generally when you migrate the network from one routing protocol to another, and the latter has a higher administrative distance.