Table of Contents
How many boards do I need calculator?
A single board foot is one square foot of wood that is one inch thick. You can measure board feet by multiplying length x width x thickness in inches, and then dividing by 144. If ordering a large amount by board feet, just multiply the total board feet needed by the price per board foot for the total cost.
How do I calculate how much lumber I need?
Board Footage. TIP: To calculate board feet: rough standard thickness X actual width X actual length divided by 144. Use the thickness of the material you intend to start with, not end with. For example, the 3/4″ top will start from 4/4 lumber.
How do I calculate shiplap?
You will take the total square footage needed and divide it by the square footage of an individual plank to get the total amount of planks needed to complete your project. Back to my example: 96 sq ft / 9.33 sq ft = 10.28 boards.
How do you calculate tongue and groove boards?
Multiply the Square Footage x 12 and then divide by the amount of coverage (in inches) each piece of wood will cover. Example: How many linear feet of 1×6 tongue and groove lumber will it take to cover 500 square feet of ceiling?
How many square feet does a 16 foot deck board cover?
7.33 square feet
EXAMPLE: Say you’ve chosen the 16-foot standard width deck board. First, take the width (5.5 inches) and convert it into feet by dividing it by 12 inches, which gives you 0.45 feet. Then multiply 0.45 by 16 to get the board’s area: 7.33 square feet.
How much lumber Do I need to build a 2 000 square foot house?
A typical 2,000 square-foot-home uses nearly 16,000 board feet of lumber and 6,000 square feet of structural panels, such as plywood. At $400 per 1,000 board feet, the lumber package for a 2,000-square-foot-home costs nearly $10,000. Check current lumber prices at the Random Lengths web site.
How many 2×4 Do I need calculator?
Calculate the Studs
- Multiply the total wall length (in feet) by 0.75 (for 16-inch on-center stud spacing).
- Add three studs for each 90-degree corner.
- Add four studs for each 45-degree corner.
- Add two studs for each wall intersection (where another wall abuts the wall you are estimating).
How many sq ft does shiplap cover?
The most common is 5 inches x 12 feet, covering 5 square feet.
How do you calculate square footage for shiplap?
To calculate the area of this shiplap, we multiply the length and width and then divide by 144 to get the result in square feet.
How much is tongue and groove per square foot?
Tongue and groove typically costs between $1.25 — $1.60 per linear foot, or around $2.50 to $3.00 per square foot. Some wood species, like cedar, will cost you way more than yellow pine or spruce.
How much extra tongue and groove do I need?
To determine the amount of trim you’ll need for your tongue and groove ceiling, you’ll need to measure each section of your ceiling’s edges. After calculating the length you’ll need, add 10% extra to your total to account for any issues that may occur when cutting your trim.