Table of Contents
What causes dashboard lights to go out?
Start by inspecting the dashboard dimmer switch to see if it was turned down or off. Then, check for a blown fuse or bad lightbulb. If the switch, fuses, and bulbs are not to blame, you likely have a wiring or electrical issue and will need to take your vehicle to a certified mechanic for diagnosis and repairs.
What fuse controls brake lights?
The stop lamp fuse is in the left kick panel inside the vehicle. It is a 15amp fuse that powers the stop light switch on the brake pedal. The brake light switch sends power to rear brake lights.
What causes brake lights not to work?
If one or more of your brake lights isn’t working properly, it could mean one of three things: The brake light system fuse is blown, the brake light bulbs are burned out or the brake light wiring switch is broken. All of these issues are easy to troubleshoot.
How do you reset dashboard lights?
How to Reset the Warning Lights on the Dash
- Open the hood of your vehicle.
- Loosen the nut that holds the negative terminal to the battery with the pliers.
- Completely remove the cable from the negative battery terminal.
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
How do you know if you have a bad brake light switch?
If the switch is bad, the brake lights won’t operate and the transmission shifter will not come out of the “Park” position. In cars with a push-button start system, a faulty brake light switch can cause the vehicle not to start. Often, the brake light switch could be sticking and work intermittently.
What should I do if my dashboard light is not working?
Then, check for a blown fuse or bad lightbulb. Fortunately, all 3 problems are relatively easy to fix. If the switch, fuses, and bulbs are not to blame, you likely have a wiring or electrical issue and will need to take your vehicle to a certified mechanic for diagnosis and repairs.
How are the tail lights and dash lights connected?
Tail lights and dash lights are connected through the tail light (and/or brake light) fuse. When the dashboard goes dark you know you are driving without tail lights. Make certain to use the exact replacement dashboard light fuse to avoid the potential of electrical failure in your vehicle’s dashboard.
What happens if you don’t adjust your light switch?
If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.
How do you replace a fuse on a Dashboard Light?
Use a fuse puller or a pair of needle nose pliers to remove the dashboard light fuse and visually inspect it for any damage. Step 3: Replace damaged fuses. If the fuse is obviously damaged or faulty, replace it with a new fuse of the same type and amp rating. Start your car and check again to see if the dashboard lights are functioning properly.