What size wire do I need for 20 amp 120-volt?
12-gauge
Why Wire Gauge Is Important
| Wire Use | Rated Ampacity | Wire Gauge |
|---|---|---|
| Low-voltage lighting and lamp cords | 10 amps | 18-gauge |
| Extension cords (light-duty) | 13 amps | 16-gauge |
| Light fixtures, lamps, lighting circuits | 15 amps | 14-gauge |
| Kitchen, bathroom, and outdoor receptacles (outlets); 120-volt air conditioners | 20 amps | 12-gauge |
What gauge wire is needed for 220v?
If you’re wiring a 220v, 20-amp outlet to run power tools, you can use the same 12-gauge wire you would use for a 110-volt, 20-amp circuit. Remember that the cable must have an extra hot wire. If the appliance draws 30 amps, you need a different type of receptacle, and the cable needs to be 10-gauge.
Can you run a 20 amp circuit on 14 gauge wire?
14 AWG must be protected at 15A, according to NEC 240.4(D)(3). 14 AWG can’t be used on a circuit with a 20A breaker.
What size wire do I need to run 100 amp Service 150 feet?
What is the right wire size for 100 Amp service 150 feet distance? You should get 2/0 AWG Copper wire or 4/0 AWG Aluminum wire for single-phase circuits. And, 1/0 AWG Copper wire or 3/0 AWG Aluminum wire if you have three-phase circuits. For these wires, the average voltage drop should be 3%.
What size wire is required for 20 amps?
A 20-amp circuit, protected by a 20-amp breaker or fuse, must be served by 12-gauge or 10-gauge wire.
Can I run a 20 amp circuit on 14 gauge wire?
14 AWG must be protected at 15A, according to NEC 240.4(D)(3). 14 AWG can’t be used on a circuit with a 20A breaker. The screw terminals are the better choice if you want to put 15 Amp receptacle on a 20 Amp circuit with 12 gauge wire. You can use the side terminals.
Why is there no neutral on 220V?
120 utilizes a neutral to complete that circuit back to source (and ground)… 220 doesn’t ‘need’ neutral because each pulse uses the off phase of the other side for this purpose and AC back and forth but where is the circuit since the power is only looping back to the hot bars.
Is it OK to mix 12 and 14 gauge wire?
It’s perfectly safe to use it. Don’t worry about confusing future workers. If they want to add something to the circuit, they will have to go turn off the circuit breaker first, and then they will see they are working with a 15 amp circuit.