Where does the waste go on a Saniflo?

Where does the waste go on a Saniflo?

Where does the Saniflo waste go? When flushed, the waste in a Saniflo toilet does not go directly to the outlet pipe. Instead, it heads to the WasteAway (soil stack) unit. Before it arrives there the Saniflo macerator technology reduces the waste to liquid form within a few seconds.

Does Saniflo need water supply?

SANIFLO installations require connection to an electrical power supply (5 amp unswitched fused spur) and water supply to the WC suite. It is possible to run the discharge from a SANIFLO unit into a septic tank.

How do you drain a Saniflo?

Firstly, switch off the Saniflo. For now, you may need to remove some of the waste by hand, especially if the waste threatens to overflow. Next, take some hot towels and place them along the length of your waste pipe. This should loosen up the frozen blockage and allow you to flush out the waste.

Can I use bleach in a Saniflo toilet?

It is important never to use products containing bleach in a saniflo macerator as bleach corrodes the seal around the macerator valve. This results in a faulty system as the macerator cannot sense when to open or close.

What are Saniflo toilets?

What is a Saniflo Toilet? A saniflo toilet (also known as a macerator toilet) differs from a conventional toilet in two ways. Secondly, instead of flushing waste through drainage in the floor, a macerating toilet system uses a centrifugal pump to flush the waste out of the toilet and into the general waste system.

Can you put a Saniflo outside?

Saniflo can easily be installed anywhere on any finished floor.

Can you wet vent a Saniflo toilet?

STEP 11: Clean, prime and glue all fittings used. STEP 12: The macerator pump must be vented into the house’s vent system, but it can be installed as a wet system vent.

Do you need a soil pipe for a Saniflo toilet?

A Saniflo is normally installed in a domestic property where there is no mains drainage pipe available. This means you can have a toilet anywhere, without worrying about mains drainage.

Can I plunge a Saniflo?

Saniflo systems allow you to install a toilet in any room of any building where there is access to a waste disposal pipe. Because of this, if you get a clog or blockage in your Saniflo, you cannot simply plunge the toilet to unblock it or you may damage the macerator.

How long does a Saniflo toilet last?

10 to 15 years
The lifetime of a Saniflo depends mainly on proper installation and proper use. However, devices typically have a lifetime of 10 to 15 years with minimal maintenance, i.e. cleaning-descaling annually, and, depending on the quality of the water in your region, the replacement of the pressure switch membrane.

How long should a Saniflo last?

Where can a saniflo toilet be installed in a house?

A Saniflo is normally installed in a domestic property where there is no mains drainage pipe available. This means you can have a toilet anywhere, without worrying about mains drainage. You could install a downstairs toilet under your stairs, create an ensuite bathroom or even install a toilet in your basement.

What kind of discharge pipe does saniflo use?

Saniflo recommends to use PVC, CPVC, copper. – What size discharge pipe should be used? Depending on the pump model, the discharge pipe can be 3/4 or 1 inch diameter pipe. The Sanicubic range uses 1-1/2″ diameter discharge pipe.

Where does the power come from for a saniflo unit?

A SANIFLO unit is normally behind a WC suite with a horizontal outlet spigot BS EN 33 or 37. SANIFLO installations require connection to an electrical power supply (5 amp unswitched fused spur) and water supply to the WC suite. It is possible to run the discharge from a SANIFLO unit into a septic tank.

How long does a saniflo toilet system last?

A Saniflo system uses much less water than a traditional flush mechanism. The system will last for more than 50,000 flushes and all grey pumps come with a 2 year warranty. Is it Easy to Install a Saniflo toilet?

https://www.youtube.com/watch?v=dWTkrLWiM3Q