How do I fix the flashing light on my Whirlpool dishwasher?
How to Reset the Blinking Light on a Whirlpool Dishwasher
- Press the “Heated Dry” button, then quickly press the “Normal” button.
- Press the “Heated Dry” button again, and press the “Normal” button again to enter the diagnostic mode.
- Close the dishwasher door if it is open, and the diagnostic cycle will run.
Why is my dishwasher start light blinking?
Common solutions for: Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. If the heating element does not have continuity, replace it.
Why does my Whirlpool dishwasher not start?
Make sure the power switch is on: Check the dishwasher’s power switch to make sure it’s turned on. Some switches may be located in a kitchen cabinet under the sink. To reset a Whirlpool dishwasher, unplug it or turn it off at the circuit breaker. After one minute, restore the dishwasher’s power to see if it starts.
What causes a dishwasher not to start?
If your dishwasher won’t start, the problem could be the door latch or door latch switches. If the door cannot close properly to activate the door latch switches or if the switches are defective, then the dishwasher controls will not receive power and the dishwasher will not start.
How do I fix my dishwasher from blinking?
If it is flashing clean light, Press HEATED DRY then NORMAL then HEATED DRY then NORMAL and allow the appliance to run for about two minutes then press CANCEL/DRAIN. Keep in mind that you should wait for the dishwater to finish the drain cycle.
Why are the lights flashing on my Whirlpool dishwasher?
Whirlpool Dishwasher Lights Flashing Whirlpool dishwasher lights may flash because the power was interrupted mid-cycle, the door opened during a cycle, or the unit was set for a delayed start. To address the issue, start by checking your unit’s power supply. If it’s powered, press Start/Resume and immediately push the door firmly.
What to do if your Whirlpool dishwasher wont start?
1. Press the rinse cycle. To run the diagnostic, start by turning the dishwasher on and pressing the rinse cycle button. 2. Turn the dishwasher off. As soon as you do that, turn the dishwasher off again. Hold the start button down while turning the dishwasher back on again.
How do I Turn Off the lock light on my Whirlpool dishwasher?
When you press and hold the lock button for four seconds, it should turn the control lock feature off. You should notice that the light indicating the lock light will turn off. For more information about this feature, consult the user manual.
What should I do if my dishwasher light is blinking?
Press the “Heated Dry” button again, and press the “Normal” button again to enter the diagnostic mode. Close the dishwasher door if it is open, and the diagnostic cycle will run. Check the dishwasher after 30 minutes to make sure the diagnostic cycle is complete, in which case the light should no longer be blinking.