Table of Contents
How do I get my Jeep Cherokee out of security mode?
Insert your key and turn the drivers side door lock to the right , then left and then right again this will reset the security system.
How do you reset the anti theft code on a Jeep Cherokee?
Wait for a chime to sound and press and release the “Lock” and “Unlock” buttons on your remote. Press and release the “Lock” button by itself and wait for the car’s chimes to sound again to indicate successful resetting. Remove the key from the ignition when you are done to finish the procedure.
How do you reset the alarm on a Jeep Grand Cherokee?
Open the driver’s side door, with all other doors closed. You’ll then need to press the LOCK button on the key fob. Then, close the driver’s side door and keep all doors closed for at leaSTSRXteen seconds. The security dash light should stop flashing quickly, indicating that the security system has been reset.
How do you turn off the security system on a 1993 Jeep Grand Cherokee?
How to Disable the Alarm on a 1993 Cherokee
- Insert the key into the door lock and turn it counterclockwise.
- Open the hood and disconnect the negative battery terminal by using a wrench to loosen the nut on the cable.
- Remove the driver’s side kick panel.
- Strip away a section of the wire with wire strippers.
How do you reset the anti theft system on a 2004 Jeep Grand Cherokee?
To reset the 2004 jeep grand cherokee security system unlock the driver’s side door with the key and then lock it, and then unlock it again and the system should be cleared.
How do you reset the security system on a 2000 Jeep Grand Cherokee?
How do I bypass the anti theft on my Jeep Grand Cherokee?
Press the power door-lock switch on the keyless entry fob. Close the driver’s side door. Leave all doors closed for about 16 seconds until the Vehicle Security Light on the instrument cluster stops flashing quickly. When the light flashes at a slower rate, this signifies that the system has been reset and rearmed.
How do you reset the security on a 2004 Jeep Grand Cherokee?
How to reset service on a Jeep Grand Cherokee?
Reset Service Jeep Grand Cherokee 1 Put the key in position 2 but do not start it. 2 Use the STEP button on your center console pressing it till the MILES TILL SERVICE is displayed. 3 Press and hold the RESET button to the left of the STEP button for 4 seconds.
Is there an anti theft system on a Jeep Cherokee?
The Cherokee is among the many Jeep vehicles that offer keyless entry and anti-theft systems. The Jeep’s remotes allow you to control your panic alarm, your door locks and your trunk release, and can be programmed completely from your driver’s seat.
How does the Immobilizer work on a Jeep Grand Cherokee?
Some models of the Jeep Grand Cherokee are equipped with an immobilizer anti-theft system that disables the engine. The system is activated when something other than an authorized key is used to try to start the engine.
How can I get my Jeep Cherokee to run?
Enter your Jeep and press the Lock button on your keyless remote five times in 10 seconds. Insert your key into the car’s ignition, turn it to the “Run” position and wait for the car’s chimes to stop.