Table of Contents
How do I get the airbag light off?
How to Reset an Airbag Light
- Put the key into the ignition and turn the switch to the “on” position.
- Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
- Repeat Steps 1 and 2 two more times.
Is airbag light expensive to fix?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Who can clear airbag codes?
Can I clear the airbag codes myself with my handheld scanner?
- MyAirbags clears all soft codes and hard codes that are stored after the vehicle was in an accident.
- Your handheld scanner can’t do it all.
- There are two types of codes:
- Soft Codes.
- Yes, most scanners can clear soft codes after the problem is solved.
How do you get the air bag light to go off?
Step 1 Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light.
How do you turn off an airbag light?
For turning OFF your airbag light you must connect a diagnostic scantool to the data link connector of the car. in order to access the Airbag ECU ( Electronic Control Unit ) and erase all faults memored. In other words reset the Airbag ECU. Then the Airbag light will turns OFF.
Can you reset airbag light?
You can reset the airbag light on your vehicle from your home garage, saving yourself a trip to the dealership or mechanic. The airbag light, also known as the SRS light (supplemental restraint system), illuminates on the vehicle’s instrument panel usually only after the vehicle has been in an accident and the airbag has deployed.
Why does the airbag light stay on?
Light stays on and warning for airbag service on reader board. If the airbag light stays on after it completes it’s “check light” process then there is a fault in the air bag system. It could be anything from a bad sensor (there are 3 of them) to a wire that has become unplugged. This problem should be repaired as soon as possible because…