Table of Contents
How do I remove a pulley with a key?
Place the assembly over the key, and then thread the bolt into the shaft as far as it will go. Spin the nut downward against the block. Then use a wrench to apply enough force on a nut to remove the key from the shaft. If you apply enough downward movement, the key will be extracted.
How do you remove a crankshaft pulley without a tool?
There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank. Just enough to break the bolt loose.
How do you remove a stuck pulley from a spindle?
Take two bolts and thread them in the two smaller holes. Tighen the bolts slowly and evenly and the pulley will drop down. Then take a small chisel and open up the vertical line in the hub. You may need to use a puller to get the hub off of the shaft, but it will come.
Do you have to remove the belt pulley on a John Deere riding mower?
Whether you are rebuilding your John Deere riding mower or you were in an accident and bent the driver belt pulley, you will have to remove the driver belt pulley to get a new pulley on so that you can get back to mowing. The drive belt pulley is the main drive pulley that is the start of all major functions with the mower.
Do you have to clean the pulley on a lawn mower?
Clean the pulley face of your device as well as the pulley side of the belt. You can tighten or replace the fasteners. It is very important. Because you will be able to avoid this type of problem by doing this. Then you have to remove oil or grease regularly if you want to avoid these types of problems in your machine. 1.
How to remove the engine pulley bolt on a craftsman lawn mower?
Craftsman Exclusives, Craftsman, Lawn Mowers, Lawn & Garden 1 Answer from this member: The engine pulley bolt is removed by turning it counterclockwise (CCW). It will likely require a 5/8″ socket and breaker bar to remove the engine pulley bolt.
What’s the best way to remove an engine pulley?
To prevent the engine from spinning over, remove the spark plug and shove about 3-4 inches of cotton rope into the spark plug hole leaving a few inches exposed. The rope will prevent the piston from reaching the top and stop the engine from spinning over so that you can loosen and remove the engine pulley bolt.