How do I reset my White Rodgers Intelli vent?

How do I reset my White Rodgers Intelli vent?

1 Manual reset is accomplished by first, turning off power to the water heater for 10 seconds. 2 Restore the power to the water heater. 3 Within 10 seconds of restoring power, press the two temperature adjust buttons simultaneously until the left (green) “Vacation” LED begins to blink (approx. 5 second delay).

How do I reset my power vent water heater?

Turn the water heater’s gas valve switch to the “OFF” position, wait for a few seconds and then flip the switch to the “ON” position to reset the system. The water heater’s gas valve is located near the bottom of the unit and connects to your home’s natural gas line.

What is flammable vapor sensor lockout?

What is a Flammable Vapor (FV) Sensor? FV Sensors are safety devices on select models of water heaters, which cause a soft lockout (a.k.a. the unit shuts down) when flammable vapors are detected near the unit, to prevent the possibility of their ignition.

What is the resistance of a flammable vapor sensor?

The sensor has a resistance of about 10-50 kOhms when it has not been exposed to natural gas or splashed with water during cleaning.

Where is the reset button on a gas hot water heater?

A water heater reset button, usually red, is located in the center of the limit switch just above the water heater thermostat. The water heater limit switch is a safety device that will shut the power down to the water heater if something malfunctions and the water gets to hot.

Can you reset a hot water heater?

Somewhere on your electric water heater, you’ll find a reset button. It’s usually red and often located near the thermostat. It may also be hidden behind a removable metal panel on the unit—and then behind some insulation. Once you find the button, push and release it.

Can you bypass a vapor sensor?

You cannot easily bypass this sensor. Merely connecting the wires together will have no effect. If your gas water heater suddenly stops working, it is very likely that this sensor is the cause.

How to get White Rogers Intelli vent controller out of lockout mode?

Here are the steps to get the controller out of lockout mode without their assistance: 1. Make sure the power cord is plugged in. 2. There is a switch located on the top of the WH on the Black thing (the blower) – turn it off for 10 seconds. 3.

How to tell if your water heater controller is in Lookout mode?

The lights on the controller will tell you if it’s in lookout or you’re screwed mode. Look for the Green (Warm/Vacation) light on the left and the Yellow (Very Hot) light on the right to be lit. This means the unit is in lock out mode. The water heater manual wants you to call a phone number but the folks on the other end can be real but heads.

Where is the resistance sensor on the Intelli vent controller?

It’s located near the bottom of the WH. It has 2 Black wires going from the controller to it and has a diameter that is about the size of a dime. Unplug the sensor and using an ohmmeter measure its resistance. It should be in the range of 20,000 to 50,000 ohms.