Menu Close

How do I reset the rear window on my Freelander?

Admin

How do I reset the rear window on my Freelander?

Here is the recalibration procedure:

  1. Disarm the alarm system.
  2. Disconnect your Freelander battery.
  3. Wait for 5 seconds.
  4. Reconnect your battery.
  5. The tailgate window will automatically go down completely.
  6. Put your key in the ignition and turn to the ‘ignition’ position.

How do I reset my Freelander 2 windows?

First Gear

  1. Close the window fully.*
  2. Release the switch, then lift it to the close* position and hold for two seconds.*
  3. Open the window fully.*
  4. Release the switch, then push it to the* open position and hold for two seconds.*
  5. Lift and release the switch to operate the*
  6. Repeat the procedure on each window.

How do you manually open a Freelander tailgate?

If you are stuck unable to get into your boot there is a little trick to open the tailgate – press the lock and unlock buttons on the dash at the same time and this will open the tailgate. The handle fits in the centre of the tailgate underneath the two number plate lights.

How do I turn off the alarm on my Freelander 2?

To silence the alarm, press either handset button, or operate the door locks using the key in the driver’s door.

How do you reset a Land Rover window?

Once the power supply is restored, reset the windows as follows:

  1. Close the window fully.
  2. Release the switch, then lift it to the close position.
  3. Release the switch.
  4. Repeat the lift and release procedure twice more.
  5. Test the window for correct manual and automatic switch operation.
  6. Repeat the procedure on each window.

How do I reset my Discovery 4 Windows?

Just reset it. Basically you close it and then lift the switch up again and hold it there for 3-4seconds. It should reset back to the auto up and down function. Just reset it.

How do I disarm my Freelander alarm?

What to do if rear door lock wont open?

To access the wire you will need cut into the insulation to access the copper (which will need taping up again afterwards). If the lock solenoid is healthy the door should unlock as soon as you make the connection. Now the door is open you can investigate where the problem is.

Why is my rear window not turning on?

If you have powered the window from another FL and it works, then the problem is in your FL wiring or control circuit. The CCU is what controls the rear window, via relays and sensors. If you have no power at the window motor.

Is there a way to open a door that won’t open?

Tricky to get at when the door won’t open but I believe it’s doable. From memory there’s not a lot to it – wires to the switch and wires to the opening mechanism, maybe also a switch that detects when the window’s dropped to allow opening.