Table of Contents
How do you remove a crankshaft position sensor?
Most crankshaft sensors will have just one mount bolt which will typically be a 10mm bolt. Use a small wrench or socket to remove the bolt by turning it counterclockwise and place to the side for safe keeping.
What to do if crankshaft angle sensor is oily?
If the crankshaft angle sensor is oily now is a good time to use a small amount of carburetor cleaner to remove the oil to get a clean start on the job. An electrical connector will be held to the sensor using a plastic clip which you much push down or pull outward to release.
Where is the crank sensor located on a car?
This crank sensor will be located at the lower section of the block and can either be at the front, rear or middle of the engine at the crankshaft level.
What should I use to clean position sensor?
Before installing the new sensor use a shop towel to clean the position sensor port hole to ensure a proper seal to the new sensor O ring. Motor oil will be present at this port so do not spray carburetor cleaner inside the port. You can spray cleaner on the shop towel to aid the cleaning process.
How much does it cost to replace a Mercedes-Benz crank position sensor?
At an auto mechanic or dealership While the prices vary based on your location the average cost of replacing the crankshaft position sensor at an auto mechanic or the Mercedes-Benz dealership vary between $250 and $400. The crankshaft position sensor cost between $100 and $150 at the dealership, that’s for the parts only. Do It Yourself Cost
Can a Certified Technician replace a crankshaft sensor?
However, if you are not comfortable doing the work yourself, a certified technician, like one from YourMechanic, can complete the crankshaft position sensor replacement for you. The most popular service booked by readers of this article is Crankshaft Position Sensor Replacement.
How does the camshaft and crankshaft position sensor work?
The camshaft and crankshaft position sensors monitor the location and speed of the camshaft and crankshaft. The camshaft position sensor monitors the rotation speed of the camshaft, which indicates valve position in the combustion cycle, while the crank position sensor monitors speed of crankshaft rotation, which gives piston location.