Menu Close

How do you replace a clock spring?

Admin

How do you replace a clock spring?

For most vehicles, the steps to remove the clock spring are as follows:

  1. Remove Steering Wheel Bolt Cover Clips.
  2. Remove SRS Airbag Control Module Bolts.
  3. Remove the SRS Airbag Control Module from the Steering Wheel (make sure you disconnect any electrical connectors)

How long does it take to change a clock spring?

This particular part is located between the steering wheel and the steering column. A clock spring is a flat cable that is wound in a spiral shape that looks similar to a clock spring. The average clock spring repair is going to take less than one hour.

What are the symptoms of a bad clock spring?

Common signs you have faulty clock spring include:

  • Illumination of the SRS/Airbag light.
  • No sound when hitting the horn.
  • Noises coming from the steering column.

How do you reset the airbag light after replacing the clock spring?

Yes, you need to reset the light with airbag scanner, but disconnecting the battery, jump the + and – cable together for few minute should do the trick as well.

Can you repair clock spring?

While it is sometimes possible to repair a damaged clock spring, it is generally better to buy a new one. Clock springs are cheap, and it’s important to have a reliable unit since they may be involved with the correct function of the driver’s airbag, the horn, cruise control, and traction and stability control systems.

Does clock spring affect turn signals?

Does the clock spring affect turn signals? Yes, the cancel cams are on the clock-spring rotor.

Will bad clock spring deploy airbags?

A bad clock spring can afflict you with more than broken volume controls. You could be left without cruise control, a functioning horn, or most importantly, a functioning airbag. In this situation, you would be unable to alert an inattentive driver and the airbag may not deploy in the event of a collision.

Can you drive with a bad clock spring?

If you try to drive a car with a faulty or broken clock spring, you will experience a lot of difficulty when you try to rotate the steering wheel, and what’s more, if you prolong this, it will cause damage to other parts of your car, too, not to mention putting yourself, as the driver, at risk.”

Will disconnecting battery reset airbag light?

Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. Remove the terminal clamp and leave it disconnected for 5-10 seconds to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.

How do I turn my airbag light off?

How to Turn Off the Airbag Light

  1. Turn on the ignition switch with your car key.
  2. Wait for the airbag warning light to turn off.
  3. Turn the ignition switch of your car back off for a little longer than three seconds.
  4. Repeat steps 1 through 3 twice to make three times total.