Table of Contents
- 1 How do you reset the change oil light on a Jeep Wrangler?
- 2 How do you reset the oil change light on a Jeep Wrangler JK?
- 3 How do you reset the change oil light on a Jeep?
- 4 Why is my oil change light still on?
- 5 How to turn off oil change required light?
- 6 How to reset the oil life monitor after an oil change?
How do you reset the change oil light on a Jeep Wrangler?
Without starting the engine, turn the ignition in the ON/RUN mode position. In the instrument cluster display, navigate to “Vehicle Info” then “Oil Life.” Push and hold the ‘OK’ button until the oil life gauge resets to 100%.
How do you reset the oil change light on a Jeep Wrangler JK?
How to Reset the Change Oil Alert on a Jeep JK
- Put your Jeep in “Park” and turn off the engine.
- Turn the ignition to the “On” notch, without starting the engine.
- Push the gas pedal to the floor three times (within ten seconds). Turn the ignition to “Off,” and then start the engine to verify that the alert is turned off.
How do you reset the oil change light on a 2013 Jeep Wrangler?
How To Reset Jeep Wrangler Oil Light after Oil Change:
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
How do you reset the change oil light on a Jeep?
Why is my oil change light still on?
If your oil light stays on even after changing your engine oil, you’re going to want to check the sensor first to rule out a malfunctioning sensor as the cause. Dirt and other particles can make their way into the oil pump, causing the sensor to falsely identify oil issues. The next common cause is low oil pressure.
How to reset the oil service Light Jeep Wrangler?
To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure: Turn the ignition switch to the ON/RUN position, do not start the engine. Fully depress the accelerator pedal slowly three times within 10 seconds.
How to turn off oil change required light?
Within a 10 second interval, push the accelerator pedal all the way down slowly three times within 10 seconds. Turn the ignition switch to the “ LOC ” position. Now when you start the vehicle, the “Oil Change Required” light should no longer be lit.
How to reset the oil life monitor after an oil change?
Follow the steps below to reset the oil life monitor after each oil change. Turn the ignition to the “RUN” position. Immediately press and release the accelerator pedal 3 times within 10 seconds. Turn the ignition off. The 3.8 liter engine holds approximately 6 quarts (5.7 liters) of 5W-20 oil when the engine oil and filter are changed.
How do you do an oil change without starting the car?
With the engine off, turn the ignition switch to “ On ” without starting the engine. Within a 10 second interval, push the accelerator pedal all the way down slowly three times within 10 seconds. Turn the ignition switch to the “ LOC ” position. Now when you start the vehicle, the “Oil Change Required” light should no longer be lit.