Menu Close

How do you set the clock on a Saturn l200?

Admin

How do you set the clock on a Saturn l200?

You can set the clock on your radio one of two ways depending on the model. You can either push and hold the RCL button and the TUNE/SEEK button at the same time, (left=hour, right=min).

How do you set the clock on a Saturn Ion?

Push the “RCL” (Recall) button and hold it in. Press the “AUTO EQ” left arrow at the same time. Listen for your radio to beep. This beep means that you can now set your clock.

How do you set the clock on a 2004 Saturn Ion?

While holding the time/clock button, press the hour(hr) button and you will go into the clock setting mode. From there you can hit either the hour or minutes buttons to adjust it. Then just hit the power button on the radio to finish it.

How do you set the clock on a 1998 Saturn sl2?

You hold the Power/Volume knob in (push on it) and then use the seek switch (or buttons). Left is minute, right is hours, or the other way around (been a while since I’ve done it)… It’s marked so you can figure it out.

How do I set the clock on my 2006 Saturn Vue?

Press the (Clock) button. Or, if equipped, press the MENU button until the clock option is displayed; and then press the pushbutton located under the clock option label. The HR, MIN, MM, DD, YYYY labels will appear on the display.

How do you set the clock on a 2006 Saturn?

1. Press the (Clock) button until the hour numbers begin flashing on the radio display. Press the button again to adjust the minute numbers.

How do you set the clock on a 1997 Saturn?

Re: How do I set the clock on a 97 SC2 IIRC, turn the radio off, then hold down the volume button to set the clock. If you look closely under the tune & scan buttons (or whatever they’re called) you’ll see a little “hr” and “min”. Use those to set the clock while holding the volume button down.

How do you set the clock on a 2007 Saturn Vue?

Press and hold the RCL button, at the same time press the TUNE/SEEK down or up arrows. Press the arrows until the correct time appears on the display. The time may be set with or ignition on or off. Press and hold the RCL button and at the same time press the AUTO EQ left (HR) or tight (MN) arrows.