Menu Close

How do you turn off the alarm on a Jeep Liberty?

Admin

How do you turn off the alarm on a Jeep Liberty?

To reset the Jeep Liberty alarm, press the control door-lock button on the keyless entry fob. Open the side door of the cab. Leave all doors closed for around 16 seconds before the Vehicle Security Light on the instrument cluster starts blinking quickly.

How do I disable remote start?

How to Disable Remote Starters

  1. Make sure your automobile is turned off and that your key is out of the ignition.
  2. Remove the dashboard panels around the ignition to locate the toggle switch underneath the steering column.
  3. Look for the module with four wires.
  4. Flip the toggle switch on this module from “On” to “Off.”

How do I turn off my Jeep alarm?

Pull on one of the front vehicle door handles with the key fob in range, if your vehicle is equipped with “Keyless Go.” Turn on the vehicle’s ignition, if all else fails. This should turn off the alarm.

How do I turn off the alarm on my Jeep?

Press the unlock button on your key fob, if your vehicle isn’t equipped with the “Keyless Go.” This should turn the alarm off and prevent it from sounding until the vehicle is locked.

Why does my alarm go off when I remote start my car?

If you factory alarm is being triggered when you remote start your vehicle, it is because your alarm is not being disarmed prior to the engine starting remotely. In general, this should be set up automatically during the installation process, but it is possible that your installer did not test this function.

How do you disconnect a car remote?

How to Disable a Keyless Car Remote

  1. Enter your car, open the driver’s-side door, unlock the door and close all the other doors on the car.
  2. Insert and remove the key from the ignition twice, and close and open the driver’s-side door twice.

How do you disconnect a remote starter battery?

How to Disconnect a Remote Start

  1. Remove the dashboard panels around the steering column to expose the starter module underneath. You can remove these panels by popping them off with a flat blade.
  2. Locate the starter module and find the wire that is connected to the car’s positive battery terminal.