How wide is the totara tree?

How wide is the totara tree?

Totara is a tree reaching 120 ft high and has a diameter of up to 6 or 7 ft through. Along with other conifers, in particular rimu, it usually forms the scattered, emergent storey stretching above the dense canopy of broadleaf trees. The bark is thick and stringy – that of P.

How big does a totara grow?

Totara can be grown to a height of 50–80 cm in 2 years in lowland nurseries, forming dense fibrous root systems similar to those of well-conditioned open-grown seedlings.

How long does it take for a totara tree to mature?

The Totara is one of the majestic forest canopy trees. A mature Totara tree reaches up to 30 metres, although this takes over 100 years. The leaves are 2.5 cm long, narrow at both ends and are dull brownish-green.

Can you trim totara?

Pruning totara If the aim is to produce straight single stems suitable for milling, form-pruning is recommended. Pruning can begin once the trees are well-established and above the height of any competing vegetation – e.g. from around 2 metres tall.

What is a rata tree?

The rata (also called northern rata) is a common tree that grows throughout the North Island and the top of the South Island (mainly along the west coast down to Greymouth). The southern rata grows across the North Island (although it is rare) and is common on the west coast of the South Island.

Does totara make good firewood?

Totara burns ferociously and produces a generous flame. As firewood, it’s a favourite of New Zealand bushmen and farmers who value its quick ignition and rapid heating properties.

How far apart do you plant totara trees?

Spacing. Totara grown for timber should be planted at a spacing of about 2 x 2.5m (2,000 stems per hectare), or at up to 4 m spacings if interplanted with nurse species such as manuka. If the trees are going to be form-pruned, stocking can be lower.

What is the fastest growing New Zealand native tree?

Kunzea ericoides (kanuka) Kanuka is a fast growing tree found throughout New Zealand in forest and scrub.

How far apart do you plant Totara trees?

Is cutting a tree illegal?

According to the Indian Forest Act, each state has laid down its own rules and regulations against felling of trees. The answer is ‘yes’, because, according to this Act, the penalty for cutting down a tree is Rs. 10,000 or 3 months imprisonment. There are several instances reported in which laymen ended up paying Rs.

Which trees Cannot be cut without the approval of the government?

Sandal is one of the tree which is not allowed to cut down without the permission of the govt.

How fast do rata trees grow?

around 30cm per year
In a very fertile environment with good moisture and plenty of room, young pōhutukawa grow at around 30cm per year in height and 5-10mm in diameter (thickness). Older trees gain around 10cm in height a year and 2mm in diameter. Rata grows at about half the rate of pōhutukawa.

How big is the Totara tree in New Zealand?

Tōtara (Podocarpus totara) is one of New Zealand’s forest giants, and the largest species in its genus. It grows to 40 metres in height, with a trunk diameter of 6 metres. It is common in lowland areas of the North and South islands on fertile, well-drained to drought-prone soils.

How big does a Podocarpus totara tree get?

Bark thick, stringy, furrowed; cast in long strips, which shroud the trunk until falling. Leaves brownish to dark green; of juveniles ca. 2 cm × 1-2 mm; of adults 1.5-3 cm × 3-4 mm, linear-lanceolate, straight to slightly falcate, acute, pungent, coriaceous, patent, sessile by narrow base, midvein distinct or obscure.

Where is the best place to plant totara?

Where there is a seed source totara is typically found establishing on the less productive slopes in pastoral hill country, as well as along riparian areas where it provides shading that is crucial to water quality enhancement.

Is the Totara tree suitable for steep slopes?

Suitability for steep slopes: Totara generally develops a wide root plate and tolerates low fertility and thin soils, making it suitable for erosion control. Totara does not coppice, the stump dies when the tree is felled. See Report: Trees for steep slopes – Totara »