What is a Ghostbuster trap?
The Trap is a sealed container that allowed the Ghostbusters to transport the spirits to the Containment Unit, where they would be released into the grid.
What was the name of the ghost in Ghostbusters?
Slimer
Slimer, originally referred as “Onionhead” and sometimes “the Mean Green Ghost”, is a character from the Ghostbusters franchise….
Slimer | |
---|---|
Created by | Dan Aykroyd and Harold Ramis (concept) Steve Johnson (design) |
What if you cross the streams?
Ghostbusters 101 Class Notes reads: “All packs have one important rule: do NOT cross the streams. This can cause a chain reaction, which may lead to total protonic reversal (or destruction at the cellular level). Crossing streams is like Russian roulette, protonic reversal may never happen. But it might.”
Can you make a real proton pack?
Proving that it’s possible to actually make a proton pack Not only are these charged particles used in nuclear physics, but the medical field uses them in proton therapy, which is used to help treat cancer. The proton stream is directed to the diseased areas of the body and used to try and destroy the bad cells.
Why is crossing the streams bad?
How to make a Ghostbusters ghost trap build?
Ghostbusters Ghost Trap Build. 1 Step 1: Trap Body. For the trap body (which holds the cartridge), I used 1/4″ MDF. The MDF I used had a veneer which was sanded off. I measured and 2 Step 2: Cartridge. 3 Step 3: Aluminum Plates and Screws. 4 Step 4: Paint, Details, and Conclusion. 5 Step 5:
How big of a lip do you need for a ghost trap?
The only part that needs 1/2″ is the lip around the opening. Cut your pieces according to the plan, test fit, and then glue. Clamping them helps them dry quicker. You can also use paint cans or other heavy objects. The cartridge display is 1/2″ and 1/4″ MDF glued up and cut according to the plans.
How big should the rear tabs be on Ghostbusters?
The rear tabs are 1/4″ MDF. They are surface glued onto the cartridge and thus very flimsy. They should be a continuous piece that is part of the cartridge’s back wall. Again, I should have done the cartridge in 1/4″ MDF and not 1/2″. That way the rear tabs could be integral and much more durable. Test fit everything.