Table of Contents
What is Lowrance Structure Scan box?
The Lowrance StructureScan system uses an LSS-1 black box sounder and proprietary transducer to add automated side and down scanning capabilities to HDS-series Lowrance MFDs. Once installed the Lowrance StructureScan system is easy to operate and use. It can be displayed full screen or in a second window.
Are Lowrance transducers interchangeable?
Re: Lowrance question Yes, the transducers and power cables are interchangeable between these three units.
What is the difference between LSS 1 and LSS2?
There will be a slight increase in range and a sharpening of the images due to the HD quality of the LSS-2. Most users have reported that the LSS1 Downscan is better quality than the LSS2. The LSS1 is shorter and more mounting friendly.
Where is the best place to mount a transducer on a boat?
starboard side
The general rule of thumb is to mount the transducer to the starboard side, which is the down stroke of most single outboard boat propellers (right hand lower unit). This side produces the least amount of turbulence and is most efficient in delivering the best performance.
Can sonar transducers be mounted side by side?
You can mount SI/DI and high speed transducers side by side on the same side of the boat without any problems. When they both transducers use the same frequency is when you may experience interference.
How do you install a StructureScan 3D transducer?
1. Choose a transducer location and then route the transducer cable to the location where the StructureScan 3D module will be installed. 2. Place the transducer bracket against the transom and then align the bottom of the transducer with the bottom of boat. Use a pencil to mark the pilot holes through the slots in the transducer bracket.
Is it possible to upgrade a car head unit?
Whether you’re looking to add some of these new features to your car, installing a serious audio upgrade or simply replacing a faulty CD player, upgrading your vehicle head unit is a very rewarding project – and not as difficult as you might think.
How do you hook up a head unit?
Plug the wiring harness adapter into the factory plug, and then plug the new head unit harness into the brown and black connectors on the adapter. Connect wiring harness you prepared earlier and plug in the antenna.
How much does it cost to replace a head unit?
A replacement head unit can cost anything from around $100 to over $1000 – depending on the brand, the type of head unit, and the variety of included features. Basic digital media players often suffice if you don’t intend to play music from physical media.