Table of Contents
Where is my oil filter located?
It is usually either on the bottom or the side of of the oil pan. The drain plug is sometimes located near the crankshaft, which is the shaft connected directly to the underside of the engine block that supplies power to the moving parts of the vehicle.
How much oil does a 2004 Chevy Malibu Maxx take?
Capacity: 4 quarts. (with filter)After refill check oil level.
How much oil does a Chevy Malibu Maxx take?
Engine Oil
| Viscosity: | 0W-30 (Below -29) 5W-30 (All TEMPS) SAE 5W-30 is preferred. |
|---|---|
| Capacity: | 4 quarts. (with filter)After refill check oil level. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
Where is the oil filter on a Chevy?
Move the drain pan so that it is under the oil filter. The filter is located on the side of the engine block near the fire wall of the car. Loosen the filter with an oil filter wrench and remove it from the car.
Are you supposed to fill the oil filter?
An age-old question is whether or not you should pre-fill your new oil filter before installing it in your vehicle. The answer? Pre-filling the filter makes the process easier if you have a large, heavy-duty truck, but if you’re just changing the oil in a smaller car, it’s not necessary.
What kind of oil do I need for a Chevy Malibu 2004?
Chevy Malibu 2004, SAE 5W-30 Full Synthetic Motor Oil, 1 Quart by Idemitsu®.
How many quarts of oil does a Chevy Malibu V6 take?
5.5 quarts. (with filter)After refill check oil level.
How do I reset my oil life?
Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.