Menu Close

Where is the fuel pump relay on a Dodge Caliber?

Admin

Where is the fuel pump relay on a Dodge Caliber?

This device is a black plastic component, set in a small box with a wiring harness attached to its underside. Its sprockets attach to the engine assembly. Depending on the make of the car, you will find the fuel pump relay under the hood or under the dashboard, near the steering wheel of the car.

Where is the IOD fuse located in a 2007 Dodge Caliber?

The Ignition-Off Draw (IOD) fuse is located in the Total Integrated Power Module (TIPM), usually found near the battery in the engine compartment.

How many fuse boxes are in a 2007 Dodge Caliber?

This vehicle has only one fuse boxAnd it is located in the engine area. To be specific, You’ll be able to find it on the driver’s side of the engine right next to the strut mount.

How do you reset the security on a 2007 Dodge Caliber?

Insert the ignition key and turn it to the on position and then attempt to start the engine (crank over), the engine wont start. With the key still in the run position wait 10 minutes and the security light should blink and then go out.

How do you reset a 2007 Dodge Caliber?

How to Reset Oil Life: Dodge Caliber 2007-2012

  1. Turn the ignition to run (second position)
  2. Press the accelerator pedal all the way down three times within 10 sec.
  3. Turn ignition OFF.
  4. Then turn the ignition to RUN or start the engine to verify if the oil life has been reset. Be the First to Share.

How do you reprogram a 2007 Dodge Caliber?

2007 Dodge Caliber

  1. Insert First Programmed Key. INSERT a working remote head key into the Ignition and TURN it to the ON/RUN position.
  2. Remove First Programmed Key.
  3. Insert Second Programmed Key.
  4. Remove Second Programmed Key.
  5. Program Remote.
  6. Program Additional Remote.
  7. Exit Programming Mode.
  8. Test Remotes.

How do I bypass Dodge anti theft?

Resetting the anti-theft system on this truck is pretty straight-forward. Get into the driver’s side seat and close, and then lock all the doors. Then, unlock just the driver’s side door, and go ahead and place the key into the ignition and turn it to the ON position. Then turn it back on.