Table of Contents
Where is the speed sensor located on a 1996 Ford Bronco?
New member. The speed sensor is located near the top of the rear differential towards the front.
What causes a bouncing speedometer?
While you are driving, if you notice the needle on the speedometer jumps erratically from one number to another, the speedometer cable is most likely damaged or the sensors on the driveshaft are not accurately sending the signal through the cable. If this occurs, the entire cable and housing needs to be replaced.
What is a PSOM in a Ford?
Most Ford vehicles are equipped with a Programmable Speedometer/Odometer Module (PSOM). The PSOM includes the odometer and the speedometer, which are electronically controlled by a programmable microprocessor.
How do I fix error code P0500?
What repairs can fix the P0500 code?
- Vehicle speed sensor drive gear replaced.
- Repair or replacement of the wiring harness.
- Vehicle speed sensor replaced.
- Poor electrical connection resolved.
What is a PSOM speedometer?
What is a PSOM speedometer? Programmable Speedometer/Odometer Module (PSOM): A module that processes vehicle speed information for use in various electronic systems. The PSOM can be programmed to accommodate various tire and axle combinations.
What does PSOM do?
The Dutch programme, PSOM, provides a capital component for machinery, buildings and materials on a grant basis (up to two-thirds of the cost)….PSOM.
| Acronym | Definition |
|---|---|
| PSOM | Programmable Speedometer Odometer Module (vehicle software) |
How to reset the speedometer on a Ford f-96?
Press and hold the RESET button on the front of the speedometer while turning the key to RUN. Release the RESET button. The pointer will prove out and some codes will appear on the odometer display.
What to do if your odometer doesn’t turn on?
Hoping someone has had some experience and knows what my issue is. 1. Put the key in the ignition and turn the engine on. 2. If your odometer looks normal, go to step 3. If it doesn’t turn on, or the digits look strange, go to step 6. 3. Wait a few minutes and look for the word “ERROR” at the obometer.
Where do I find Revs on my speedometer?
Verify proper speedometer operation. To find conversion constants for tires with 15 inch rims that are not listed in chart, above multiply the revolutions per mile (at 45mph) of your tire times .0135. For 16 inch rims multiply by .015. The revs/mile can be found at your tire manufacturers web site.
Where is dealer mode enable wire on Ford f-96?
Locate the dealer mode programming enable single-terminal connector. The connector is located at the bottom of the instrument panel below the center of the glove box. On all vehicles, the dealer mode enable wire is Circuit #567 (LB/Y). Insert metal clip in service wire panel connector.