Table of Contents
What device transports data around the motherboard?
Buses
Buses are circuits on the motherboard that connect the CPU to other components. There are many buses on the motherboard. A bus moves instructions and data around the system.
What is the collection of wires connecting the CPU with main memory called?
Address buses
Address buses are made up of a collection of wires connecting the CPU with main memory that is used to identify particular locations (addresses) in main memory.
What is a jumper in motherboard?
In a computer, a jumper is a pair of prongs that are electrical contact points set into the computer motherboard or an adapter card . When you set a jumper, you place a plug on the prongs that completes a contact. In effect, the jumper acts as a switch by closing (or opening) an electrical circuit.
How does communication occur between devices on the motherboard?
The interrupts (referred to as IRQs) are hardwired to the ports on the motherboard and cannot be reallocated. Communication occurs using I/O and memory addresses that can be reallocated among the ports. To function, each device must have the IRQ, I/O, and memory addresses configured properly at boot.
What is another name for a motherboard?
A motherboard (sometimes alternatively known as the mainboard, system board, planar board or logic board, or colloquially, a mobo) is the main printed circuit board (PCB) found in computers and other expandable systems.
What is on the motherboard?
The motherboard accommodates the central processing unit (CPU), random access memory (RAM), expansion slots, heat sink and fan assembly, basic input/output system (BIOS) chip, chipset, and the circuitry that interconnects the motherboard components.
Which is a collection of wires?
➪ SYSTEM BUS is a collection of wires.
Which computer bus connects the main memory to the memory controller in computer systems?
The internal bus, also known as internal data bus, memory bus, system bus or Front-Side-Bus, connects all the internal components of a computer, such as CPU and memory, to the motherboard. Internal data buses are also referred to as a local bus, because they are intended to connect to local devices.
What is jumper device?
A small, plastic-covered metal block that is pushed onto two pins to close a circuit. An alternative to the DIP switch, the jumper is a less costly on/off switch found on motherboards and peripheral devices for one-time configuration.
What is jumper configuration?
In electronics and particularly computing, a jumper is a short length of conductor used to close, open or bypass part of an electronic circuit. They are typically used to set up or configure printed circuit boards, such as the motherboards of computers. The process of setting a jumper is often called strapping.
How does device to device communication work?
Device to device communication is an advanced data transmission technology developed to increase the efficiency of network. In LTE -Direct, D2D communication enabled devices can interact each other using a secure transmission protocol similar to the devices communicate with the base station.
How do hardware components communicate?
The electrical circuits on the board allow the components to receive power and communicate with each other. A desktop computer motherboard usually contains the CPU and the main memory, and you can attach graphics and sound cards, memory, and other peripherals to them with cards or cables.